Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Switching Jaws

Posts

Switching Jaws

#1

Switching Jaws

Allen Neighbors

>A friend just ordered the Grizzly 3-3/4" 4-jaw Chuck.

I've done a number of searches of the archives, and can't find an answer to my questions.

Will the SuperNova2 Jaws fit it?

Another Question: Will the SN2 jaws interchange with the Vicmarc Chucks? If so, which Vicmarc Chuck?

Thanks for your help.

Re: Switching Jaws

#2

Re: Switching Jaws

Jorge Castaneda

>Allen,

Vicmarc and Supernova 2 are not interchangable.

The Grizly I think can acomodate the Vicmarc jaws, hope someone confirms or denies this. Call Grizly, they must know.

Jorge

Re: Switching Jaws

#3

Re: Switching Jaws

Gil Jones on Lake Seminole GA

>I have VicMarc VM100 and a Grizzly H6265 chucks. They are about 3 1/2" dia., 4-jaw scroll chucks, and they are so nearly identical that all related jaws are interchangeable (at least on my two chucks). The Grizzly is a tad less than half the cost of the VicMarc. The VicMarc is smoother scrolling than the Grizzly, and may be made of better steel than the Grizzly, but in use they perform the same for me.

Gil

Re: Switching Jaws

#4

Ditto what gil said

john lucas

>

Re: Switching Jaws

#5

Re: Thanks, Gil and Jorge

Allen Neighbors

>That's what I needed to know. My friend, who is just getting started in Woodturning, wanted to buy the least expensive Chuck that he could to get started with (Grizzly H6265). He wanted to buy one that he could get a set of Cole Jaws to fit. Now I can tell him that the Vicmarc jaws will fit the Grizzly chuck.

I wanted to know the SN2/Vicmarc information just for myself. I have two SN2s but neither will fit my Oneway Spindle, so I'm using a spindle adapter that I purchased from Bestwoodtools (if that's the way they're listed), and I get a little too much runout for my liking. There is always a bit too much slop when I reverse my pieces to finish the bottom.

When I bought the little Vicmarc VL100 from TD, I installed a 1"X8tpi adapter on one of my chucks so it would fit the Vic. I found out what it's like to turn on a lathe without runout, and I like it!! When I reverse a piece on the Vicmarc, I have to really screw up to get any slop. :D

I guess I'm going to have to spring for a new Chuck, in order to not have to use a spindle adapter... M33x3.5 threads... :(

Re: Switching Jaws

#6

Re: Thanks, John,

Allen Neighbors

>I've got a query in to Tim Geist about a Nova Titan chuck with M33x3.5 threads. Maybe I can get out a little cheaper that way.

Wish I could find someone that would like to trade a M33 threaded chuck for a 1 1/4"x8 threaded Chuck. :)