Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Ebonizing Brew

Posts

Ebonizing Brew

#1

Ebonizing Brew

Paul Zerjay

>I made a mixture of DNA and trans tint dye to make my own ebonizing stain. Thinking the alcohol would flash off quickly, I tried putting a clear coat of deft spray on 1/2 hr after the ebonizing mixture. The results were less than impressive, with the deft sitting on the surface in some spots, and soaking in to the point it would dissappear in other spots. The wood is hard maple. Can anyone give me a tip for a clear coat over my mixture? TIA

Re: Ebonizing Brew

#2

Re: Ebonizing Brew

GaryG in MD

>Paul,

You didn't say to what extent your sanded the piece before ebonizing, but the thing you appear to have skipped is sealing the piece before or after the ebonizing. Indeed, many people use Deft as a sealer. If your ebonizing is not blotchy, and you're happy with it, sounds like you may want to sand again and apply more coats of Deft until it stops soaking in. Then you can do your final sanding/buffing to the final sheen you desire.

Let's see it when you're done. ...Gary

Re: Ebonizing Brew

#3

Re: Ebonizing Brew

Jim Terry

>Paul, I just finished several pieces of hard maple using that process this afternoon. I applied several coats of Trans Tint in DNA and gave it a few minutes to dry then cut the raised grain back with 1000 grit and applied more dye. When that was dry I buffed it with a paper towel and sprayed several coats of Deft. Let each coat soak in and dry before applying the next. After I was satisfied with the finish I let it cure for an hour or so and lightly buffed it with 0000, buffed with cloth and waxed. Hope you have better luck next time. Jim

Re: Ebonizing Brew

#4

Seal with shellac?

Jerry Hall

>I am not an expert in this, but in general I have found Shellac to be a universal sealer/blocker, that is compatible with other surface finishes. Worth a try?