Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

JAW CHUCK USAGE

Posts

JAW CHUCK USAGE

#1

JAW CHUCK USAGE

Bill Hale / The Wood Spinner

>I have been ask many times about jaw chuck mounting and how big can you turn using one.

I have included a pic showing a Piece of Pistachio mounted in a Vic. chuck. I start between centers and rough out the outide and turn a spigout on the bottom. In this case it is 5 " Dia. I then turn the piece around and chuck to the bottom. As this piece weighed in at about 60 lbs after outside roughing I use the tail stock live center to assist holding. I do not remove it until the piece is fully roughed out.

Finished size 17 1/2 " x 9 1/2


img

Re: JAW CHUCK USAGE

#2

question on blank`

jared

>I was just wondering what you planned to do with what appears to be cracks in the bottem of the bowl? Fill them with something or just leave them as they are. It doesnt appear that they will be turned away. Jared

Re: JAW CHUCK USAGE

#3

Re: JAW CHUCK USAGE

Steve Russell

>Hello Bill,

Great post on using a Vic on a big one! I've used the Vicmarc multi-segmented jaws on bowls up to 42" in diameter with great success. The last one I turned (outbound side of a Oneway 2436) was 42" in diameter (rough size) and 7" deep. The finished size was 32" in diameter and 5" deep.

This bowl was turned from White Ash and unfortunately, it had a folded bark inclusion on one side that required turning off quite a bit of the rim diameter and height to remove the defects, hence the size reduction. I love my Vicmarc's!!! Take care and all the best to you and yours!

Steve Russell

EWW, WVP, EWWFS

The Woodlands, Texas