Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Okay, I believe ...

Posts

Okay, I believe ...

#1

Okay, I believe ...

Ed Moore

>the compliments about the cut of the Hunter tools.

I bought the #3 a couple of weeks ago and today I finally got to use it. I made a small fruitwood goblet - I think it is pear. I used the Hunter tool to smooth and shape the inside of the cup. It worked so well that I started sanding with 320 or 400 and it is usually 80 grit or maybe 150. The interior of the goblet was incredibly smooth when I got dome turning that part. I look forward to turning more goblets.

Maybe I can make a Chinese hat box tomorrow with the Hunter tool. Hmmm! ..... Smoooooootthhhh .....

Ed

Re: Okay, I believe ...

#2

Question

Barbara Gill, Remlik VA

>How does the Hunter performance compare to the Eliminator?

Re: Okay, I believe ...

#3

I am not familiar with ...

Ed Moore

>the Eliminator. I just know that I had complete control - there is almost no learning curve, the shavings were wispy when I was smoothing and making that last cut, and the results were quite gratifying.

Sorry, I can't compare for you.

Ed

Re: Okay, I believe ...

#4

Re: Question

john lucas

>I've never owned the eliminator but it sits at one angle. I don't know how hard it is to rock it into a steeper angle if you want. With the Hunter tools you can easily use it at what ever angle you think works best. They are also a whole lot less expensive. The actual cutter looks the same but I don't know because I've never owned the eliminator.

The only downside of the hunter is having to make your own handle but most people can handle that.

Re: Okay, I believe ...

#5

John, the Hunter tools at ...

Ed Moore

>Woodcraft had handles and they are fine. With the club discount and no shipping, it was cheaper to get the tool from Woodcraft than it was from Hunter Tools. Go figure.

Ed

Re: Okay, I believe ...

#6

Thanks

Barbara Gill, Remlik VA

>

Re: Okay, I believe ...

#7

Hmmmmm...

Jennifer@Indy.USA

>I was standing in Woodcraft today holding the #3 tool with a 10% off coupon in the other. Pondered, pondered some more...put it back and bought the Flexcut detail reciprocating gouges instead.

I'll wait for the next flyer and get one then. You've convinced me.

Jen :)

Re: Okay, I believe ...

#8

The handles are very nice too.

Jennifer@Indy.USA

>

Re: Okay, I believe ...

#9

Re: Okay, I believe ...

George Van

>Exactly the same experience I have had Ed. I have the 3/4", #6 coming as I think this will be pretty vibration free on the hollowing rig also.I think the cutter will work on the Rolly Munro tool very well also. I will know next week.