Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

PM3520 bed twist

Posts

PM3520 bed twist

#1

PM3520 bed twist

John Dillbeck

>A thread a few days ago talked about horizontal alignment and bed twist and mentioned using a machinist level to measure. Also using winding sticks. My 3520 is misaligned a few thousand and I have lived it for years.My method of checking for bed twist was using a cheap 6in. laser dot level. On each end of the bed angled toward the center and projecting about 15 ft. Mark the center of the dot go to the other end and superimpose the dot. I was about 3/8in. off. Raised one foot about 1/2 turn and the dots are dead on and so are the centers.

Re: PM3520 bed twist

#2

Re: PM3520 bed twist

E.T.

>Was this reallignment immediate or did it take place over an extended period of time? If, it was immediate that means the cast iron is fairly flexible, doesn't it? I thought CI would twist with passage of time but movement of 3/8 to 1/2 inch over 36 inches???

That means we should be careful about how we set up our CI lathes. ET

Re: PM3520 bed twist

#3

Re: PM3520 bed twist

Brodie Brickey

>The laser dot was project across '15 feet' and marked. That's why it showed so much difference. I don't think the cast iron is the problem. Its not fine tuning the lathe when you setup. If the lathe ain't sitting level, you will eventually have a problem.

Brodie