Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Homemade small hollowers

Posts

Homemade small hollowers

#1

Homemade small hollowers

eric_s

>Awhile ago I asked for help/advice on small hollowing tools. John Lucas was kind enough to post pictures and advice. Here are my attempts using 3/16 allen wrenches, they took awhile because the drive belt on my mini snapped and while living out in the sticks has its advantages, ready access to replacement parts is not one of them.

The smaller one can be used very aggressively, the larger one needs to be rehandled and the working end shorted (too much chatter). They both work exceptionally well at blowing up small test forms. :-)

Thanks again to all who replied originally.

Eric


img

Re: Homemade small hollowers

#2

Re: Homemade small hollowers

john lucas

>eric just come down the shaft of the longer tool about 1 or 2 inches and bend it to the right so the cutting tip is aligned with the point where the tool goes into the handle. This will stop a lot of the torque but won't necessarily eliminate chatter. The only way to stop chatter is to not hang so much tool over the tool rest or to make the tool larger.