Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Getting under deep shoulders of HFs

Posts

Getting under deep shoulders of HFs

#1

Aage Rendalen

Getting under deep shoulders of HFs

Aage Rendalen

>I recently bought the Jamison system, and I'm having trouble getting under the shoulders of Southwestern type HFs. The back gate imposes limits on the angle of the boring bar, and for deep shoulders I've had to pull out my manual Kelton hooks to get in as deep as I want.

I've looked at the end of the boring bar cut at 45 degrees but it does not seem very promising to me.

How do the rest of you deal with these deep-shouldered vessels?

Re: Getting under deep shoulders of HFs

#2

Don Pencil armbrace with curved shaft

TDaniel

>There are others that will also work but this is the one I have been using for several years now. I actually have 5 of them so I don't have to change tips but 3 would be enough. If you aren't in a big hurry you can do just fine with one.

Re: Getting under deep shoulders of HFs

#3

Re: Don Pencil armbrace with curved shaft

George Van

>Terry, are you saying you have five of Don's curved tip bars? What tips do you use on them to equip so many?

Re: Getting under deep shoulders of HFs

#4

yes, 5 armbraces

TDaniel

>George I have 2 with straight bars and 3 with curved ones. I keep a 1/4" square tip in one of the straight bars a the other has a Kelton end from my old Kelton captured rig. Then I have an offset 3/16" cutter mounted in a curved shaft that I use for "digging". Once I dig down a couple of inches I go to a teardrop cutter (small one) and clean up the ridges. When I finally get to the bottom I go to a big teardrop cutter to do a final clean-up. I rarely go to the VL300 with the Jamieson to hollow because it limits my shapes too much. I don't like domed tops all that much. When I go to a show there are few, if any, other flat topped pieces there. Having the extra handles and braces just makes things go a lot faster.