Elm Hollowform
steve antonucci
>This pot is about 12" tall and 5" wide, hollowed to about 3/16" throughout. I'm debating "carving it" to provide texture along the growth rings with my Dremel. Or not. Comments welcome.
Steven
Knowledge You Can Build On — Est. 1998
Elm Hollowform
steve antonucci
>This pot is about 12" tall and 5" wide, hollowed to about 3/16" throughout. I'm debating "carving it" to provide texture along the growth rings with my Dremel. Or not. Comments welcome.
Steven
Re: Elm Hollowform
Dominic Greco in Richboro PA
>Hi Steve,
Excellent looking! I would leave it as it is! I think anything else on this would compete with the form, as well as the grain.
This is the stuff you got from Andy, right?
See ya around,
Dominic
Same log- from the day Andy and I cut...
steve antonucci
>
Re: Elm Hollowform
George Van
>I agree with Dominic on this one. There is enough going on with the figure and the movement of the growth rings to try to add more and hope to have an improvement.
My Vote is No
Ric Taylor
>I think there is beautiful figure in that wood, and anything you add to it will be too much. In this case, just let the wood speak for itself.
Ric
Re: Elm Hollowform
eaglesc
>If it aint broke don't fix it.
Sometimes when you have to debate on whether to do something or not the mental fisticuffs stems from the fact that your inner voice is telling you
"It's done"
Beautiful!
But hey !
What do I know, I only make pens!
Re: Elm Hollowform
Ed Karch
>You got natural edge, heart/sap contrast, pin knots and grain, that is three points stop there.