Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Coring from headstock side?

Posts

Coring from headstock side?

#1

Coring from headstock side?

Leppikallio

>Yes, its me again with my funny questions.

Does anyone know if there still is somewhere those "wrong handed" McNaughton knives available? So that at least those big cores could be removed from headstock side. I'm sure I have seen those somewhere but now I just can't find them anywhere (online). Could someone give me some pointers?

Re: Coring from headstock side?

#2

Re: Coring from headstock side?

Gordon Seto

>Greg Jensen is the US rep for McNaughton,P&N and VB-36, give him an email.

gnjensen@cox.net

Gordon

Re: Coring from headstock side?

#3

Re: Coring from headstock side?

Steve Russell

>Hello,

I have several of the left handed knives from Kel McNaughton and they work very well! I know they are still available, but they can be hard to get here in the U.S. Greg Jensen (Gordon gave you his contact info) would be the easiest way for you to get a set, as most of the US suppliers do not carry the left handed versions of Kel's legendary center saver knives. Good luck to you and best wishes in all of your woodturning endeavors!

Steve Russell

EWW, WVP, EWWFS

The Woodlands, Texas

Re: Coring from headstock side?

#4

It's not clear to me why ......

Jamie Donaldson

>... you would want to attempt such an operation- wouldn't the piece cored off be the exterior and fly around the shop when set free???

Re: Coring from headstock side?

#5

Re: It's not clear to me why ......

Fog Tanner

>No more so than coring from the tailstock side. You core down close to the bottom and turn the speed down as you get close to the bottom. Stop and "tap" the bowl to see of the piece will break free, if it does go on to the next one. If not, core a little more and repeat. If you misjudge and the bowls comes off, the speed should be slow enough that it doesn't go flying - not a fun experience - it should just fall on the bed. But normally, I will "pop" then off before I cut all the way around.

Re: Coring from headstock side?

#6

Re: It's not clear to me why ......

Leppikallio

>This way you are able to turn tenons for chuck as you have removed outer bowl. So no need to rechuck cores for turning foot.