Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Blackened lathe ways: how to clean?

Posts

Blackened lathe ways: how to clean?

#1

Aage Rendalen

Blackened lathe ways: how to clean?

Aage Rendalen

>I knew that oak would stain the lathe ways because of its high tannin contents but was not prepared for cherry to do the same. Now my lathe is quite black on top and my hands are badly stained. What do you recommend I do, and, short of covering the lathe, is there a way to keep this from reoccuring?

Re: Blackened lathe ways: how to clean?

#2

Re: Blackened lathe ways: how to clean?

Charles Watson

>Covering the bed ways is the only way I know to prevent this, but steel wool and WD40 should clean it---works for me. As for your hands, lemon juice will remove the stains.

Re: Blackened lathe ways: how to clean?

#3

Re: Blackened lathe ways: how to clean?

Allen Neighbors

>I have a piece of canvas about 18x24 inches, that I stick over my ways before I use superglue or any finishes.

To clean off gunk that is inadvertantly spilled, I use a putty knife, carefully, then mineral spirits, or whatever it takes to clean off the gunk. Then I use 400 grit wet or dry on a flat block of wood to clean the black stains. Then I wipe down with mineral spirits again, and wipe it off with a clean rag.

The piece of canvas keeps the time-consuming cleaning down to a minimum.

Re: Blackened lathe ways: how to clean?

#4

Re: Blackened lathe ways: how to clean?

john lucas

>Lemon juice will remove the stain from your hands. I use WD 40 and 4/0 steel wool to clean the bed. I will also spray it liberally before I start turning. If I'm going to turn a lot of cherry I will clean the ways with mineral spirits followed by Johnsons's paste wax. then I will wax it frequently until I'm done with that batch.

Re: Blackened lathe ways: how to clean?

#5

Re: Blackened lathe ways: how to clean?

Rick Allen

>Wax will protect the lathe bed from reacting with the tannin in Oak and Cherry. If you turn a lot of that wood wet you will likely reapply wax to the bed a few times. Wax also make adjusting the banjo a dream.

I have used motor oil to clean off the lathe bed. It must be the detergents found in many motor oils that did the work. Or maybe it was the paper towel I applied the oil with.

I don't like to leave a lose piece of cloth or canvas on the ways when wood is spinning. I worry that the cloth will get "involved" in the process. I don't want to get flailed by the "cat-o-9-tails" that the cloth might become. I could attach the cloth but then my movement of the banjo is inhibited.

Re: Blackened lathe ways: how to clean?

#6

Re: Blackened lathe ways: how to clean?

Bruce Lane

>I had read somewhere, may have been here, that by cleaning the surfaces and applying gun blue will prevent rust. I wonder if it will also prevent this staining? I have used the gun blue on the band saw table with very good results.