Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Follow up on silver soldering post

Posts

Follow up on silver soldering post

#1

Follow up on silver soldering post

Don henthorn

>Tried all the suggestions from a couple of days ago and even ground the two surfaces to make sure they were clean. No luck. This is crazy; I used to do this with no problem. Any way I used Mark M's suggestion and got the hole drilled in the end of the 3/8" rod and used the CA glue and it worked. One tool down and the hook tool to go. The next one is 5/16" drill rod which is going to be more of a challenge to drill. I got to keep on trucking.(G)

Re: Follow up on silver soldering post

#2

Re: Follow up on silver soldering

Mark Mandell - Gone Round In Jersey

>Glad it's working out for you, Don.

What kind of flux were you using? If your metal's clean and grease-free, I'd have to wonder if your flux may be contaminated.

mm

Re: Follow up on silver soldering post

#3

Re: Follow up on silver soldering post

Mike Cunningham (Cape May NJ)

>It's no problem at all if your drilling on the lathe. Simply mount a scroll chuck on the headstock, bring the rod through the headstock and hold it with the closed jaws and it's centered to the drill chuck. I use a starter bit and then go to the required diameter bit. If needed, bend the drill rod later. I've been using the CA method since I read about Ellsworth doing it a few years back.

Re: Follow up on silver soldering post

#4

Dick Hines

Re: Follow up on silver soldering post

Dick Hines

>maybe you are not getting the rod hot enough. Get a tank of MAP gas. I bet that will heater' up.

Re: Follow up on silver soldering post

#5

Re: Follow up on silver soldering post *LINK*

Bill Turpin in WNC mountains

>Silver soldering with steel is a contest between enough heat and TOO MUCH. If the steel gets hot enough to turn dark, no solder will stick. Read the WC article at the following link.

Bill in WNC mountains


soldering article

Re: Follow up on silver soldering post

#6

Re: Follow up on silver soldering post

eliot d

>What a fine post! I use the Ellsworth method of just gluing with CA. But if I ever wanted to silver solder, I've saved your link.