Re: Best Mini/Midi for the $$ ? *LINK*
charlie b
>I'm assuming that you have turning tools and
a chuck or two, with extra jaw sets. If not,
the price of the lathe will be your smallest
expense ; ). Consider how you're going to
sharpen your chisels and gouges. Dull tools
can lead to accidents. Not good when far
from home.
I've had the JET VS mini (or is it a midi?) which
runs around $329-$359. comes with a live
tail center and a spur drive center, along with
a cast iron tool rest. Has a 10" swing, though
you can't get the tool rest banjo under a 10"
piece, about 12" between centers and weighs
may 50 pounds.
The variable speed is REAL handy. Lets you
go "slow" (I think the lowest rpms is 500) or
faster (1200 rpms) without changing the belt
over to another set of pulleys. By changing
belt to the other pulleys you can go 1100 -
2600 and 1700 - 3900 (haven't gotten off
the first set of pulleys - yet).
I've turned bowls up to 9" diameter and 4"
deep - from bandsawn roughly to round
blanks - little itty bitty things and everything
in between on the JET in the last three years.
Other than a tool rest that broke, have had
no problem at all with it. I can bog it down if
I try, but lighter cuts make up for raw grunt
torque (the motor isn't that big - 3A, "1/2 hp").
Most of the major scroll chuck makers have
adapters for mounting their chucks to the
JET VS mini/midi - which is nice.
You can get a bed extension for this thing
that'll let you do baseball bats and table
legs or stair ballisters if you want to -though
a bigger lathe would be better.
This is a great little lathe and pretty bullet
proof.
charlie b
ps Want to turn a Wig Stand? You can on
the JET VS mini
Wig Stand on a JET VS mini