Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Natural Edge Question

Posts

Natural Edge Question

#1

Natural Edge Question

Steve in NC

>I stopped by a construction site and picked up a few logs out of the burn pile. (It broke my heart to see what was about to be burned.) I took a birch log about 12' diameter and turned a natural edge bowl.

Normally with green wood, I rough turn let dry final turn, and finish. What sequence do you use with a natural edge bowls? I sanded to 400 and figured that I could let it dry and then apply the finish but now the grain is raising so more sanding will be required.

What is the correct turning, sanding, drying, finishing sequence for NE bowls.

Thanks

Steve

Re: Natural Edge Question

#2

Re: Natural Edge Question

john lucas

>steve I usually do it one of two ways. One is to completely turn it and sand with the courser grits and then put it up to dry. When dry I put it back on the lathe with the vacuum chuck and power sand with the lathe off.

The other way is to turn, then dry the surface with a hair dryer and sand. These are usually fairly thin bowls so they will warp and dry fairly quickly. I only heat it enough that I can sand without clogging the paper. I got the hair dryer at the flea mkt for $3.

Re: Natural Edge Question

#3

Re: Natural Edge Question

Dave Neighbors

>If you turn it thin enough, you can use your air hose and blow the moisture out by holding the nozzle right up against the walls. Your not going to get it all, but it will speed up the drying process

Re: Natural Edge Question

#4

Re: Natural Edge Question - Thanks

Steve in NC

>Thanks for the advice. I will give both methods a try.

Steve