>This is what I can remember of the shape my Mother's old powder box had. The wood is Butternut. It's 4" dia X 3" tall, lid separates at the center burn line.
Sanded to 400 grit, and finished with my Lacquer wash, and buffed.
The lid pops.
Critiques or comments welcome.
Thanks for looking.
Allen
Already almost 90 degrees in Childress, TX. I love it!
>with my 3 point tool, then use a scrap of formica, that I have sanded to a near point on my 80 grit belt sander. I sand the slick plastic off the flat, too, so it doesn't melt up over the edge of the groove. It makes sort of a knife point shape, that burns all the way to the bottom of the groove. Then I just turn up the speed of the lathe to about 12-1500 rpm and stick the point into the groove. I add enough pressure to make it begin to burn, and watch the other side of the ring until it gets the burn the way I want it. I do the smaller circles first, that way there's always a point to begin the larger ones... difficult to explain in words, but if you try it, you'll understand it better. :)
>That is a very nice looking powder box. I am surprised you made the lid a tight fit as most women would want to lift the lid off, take out powderpuff and address those areas where a lady might begin to glow during hot weather....My grandmother had a tortoise shell powder box that was probably some kind of primitive plastic that sat on her dresser. I will never forget the fragrance....
>Thanks for the comments, Mike. Yeah, I remember the fragrance, and the fact that the lid didn't fit tight. I didn't make it to be used for powder (that's just what I called it)... the wife says it's for the nightstand by the bed, to hold rings and earings at night... or for the window ledge above the sink to hold jewelry while in the kitchen... or for... you get the idea. :)