Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Hunter #4 Turning Tool

Posts

Hunter #4 Turning Tool

#1

Hunter #4 Turning Tool

Patrick Schupbach

>Does anyone have experience with this new tool? It has a carbide cutter which can be rotated.It recieved good reviews.Any feedback would be great, thanks!

Re: Hunter #4 Turning Tool

#3

Re: Hunter #4 Turning Tool

john lucas

>I've been using the snot out of mine for the last 3 or 4 weeks. It's great for hollowing boxes and will probably replace my old methods. I just started using it to hollow larger vessels. I have hollowed 6 ash boxes, 2 spalted maple boxes, Part of a bowl, a very thin 8" vase and partially hollowed 2 10" box elder vessels. It doesn't seem dull at all yet.

I also have the #3 and I think I'm going to mount it in a 3/4" bar to use in my arm brace. This would allow me to completely hollow larger vessels. I put the #4 in a wooden handle so it won't reach in very far.

Re: Hunter #4 Turning Tool

#4

Re: Hunter #4 Turning Tool

Jennifer@Indy.USA

>John,

Where are you buying these unhandled?

Jen

Re: Hunter #4 Turning Tool

#5

Re: Hunter #4 Turning Tool

john lucas

>Jennifer I don't have these bookmarked at work apparently. If someone else doesn't get back with you I'll send it out tonight. My glass artist just arrived so I'll shooting glass for the next 3 or 4 hours. have fun.

Re: Hunter #4 Turning Tool

#6

Re: Hunter #4 Turning Tool

Bob Fawcett

>They are listed unhandled on the Hunter site. There is a link in "Marketplace".

Re: Hunter #4 Turning Tool

#7

Re: Hunter #4 Turning Tool

Norm Smith in Nova Scotia

>Jen, Craft supplies sell them with or without handles.

Re: Hunter #4 Turning Tool

#8

Re: Hunter Cutters *LINK*

Mark Mandell - Gone Round In Jersey

>Jen,

Woodcraft sells the cutters (including their special large 3/4" one) without tool shaft or handle. See the link.

Should be simple to mount them on your own drill stock shafts. I'm thinking about doing just that with my captured system. I've got 1" and 1-1/4" boring bars that will take an insert that will hold these cutters just fine.

mm


Hunter @ Woodcraft

Re: Hunter #4 Turning Tool

#9

Re: Hunter Cutters

john lucas

>Mike just sent me an e-mail to say that they do have the unhandled #3 and #4 Hunter tools at Woodcraft.

Re: Hunter #4 Turning Tool

#10

Re: Hunter #4 Turning Tool

Bill Turpin in WNC mountains

>My wife and I just spent a week at Arrowmont (stealth gloat). She brought two of her Hunters along to share with the class. All the class members liked them better than the methods taught in the class. The head instructor said, "I'M IMPRESSED!" The #3 purchased at Louisville in '06 has been "sharpened" only twice and has turned well over 100 maple pieces. This is a wonderful tool.

Bill in WNC mountains