Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Burning Dogwood?

Posts

Burning Dogwood?

#1

Burning Dogwood?

Barbara Gill, Remlik VA

>I know Carole discovered that burning a line in Dogwood with friction heat doesn't work. Has anyone tried pyrography on Dogwood? I would think that because it is fairly hard and usually is slow growing it would be a good candidate for decorative burning.

Re: Burning Dogwood?

#2

Re: Burning Dogwood?

Russ Fairfield

>Dogwood burns really good in an open BBQ, and even better in a smokehouse. I have never tried burning it on a lathe.

Re: Burning Dogwood?

#3

Re: Burning Dogwood?

Barbara Gill, Remlik VA

>I will have to make sure I set aside the scraps for Dan and his cooking.

Re: Burning Dogwood?

#4

Re: Burning Dogwood?

Frederick Nelson

>I have had success with burning lines in dogwood with a wire on the lathe. I first cut a very shallow groove in the desired location and used a wire stretched on a one-piece holder. I did notice it took a bit longer to get a nice, dark line that didn't show white wood at the bottom of the groove. The other suggestion is to make sure you are using the same section of wire to build up the friction.

Fred

Under scattered clouds in eastern Missouri

Re: Burning Dogwood?

#5

Re: Burning Dogwood?

Jimiles-Charlotte, NC

>Yes - cut a groove and burn it.

A piece of Formica type counter top laminante works well also , you can do places with it that wire won't work for - such as inside a bowl or do circles on a flat piece ( A flat face where the tailstock would meet the wood ) Hint if you use oil to sand with or finish, burn lines before you oil, Oil lubricates the wood and makes it much harder to burn.