Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

texture with electric engraver

Posts

texture with electric engraver

#1

texture with electric engraver

ken chase

>I was told engravers are good to use for subtle texture. I looked at ebay and didn't know if I needed to spend about $25.00 for a Dremel or much less for one of the many other models listed. The effect I wish to get is like the fine texture I have seen on many John Jordan pieces. Suggestions and advise will be appreciated.

Thanks

Ken

Re: texture with electric engraver

#2

Re: texture with electric engraver

john lucas

>Ken I use an offbrand engraver that I bought at the flea mkt. I toss the pointed engraver tip and then take a 1/8" drill bit or other 1/8" shank and round it over so the end is smooth. Then you just scribble on the wood to create whatever pattern you want.

I don't use the same engraver that I sign with. Texturing with an engraver is hard on the bearings. It still works but it makes it harder to write legibly so I have a good quality Dremel engraver that I use for signatures.

Re: texture with electric engraver

#3

Re: texture with electric engraver

Jennifer@Indy.USA

>Ken I've been using a Dremel engraver (Lowes $19.99) for years. I round over one end of the engraving bit to use for subtle texture and then also use the other end for signatures and a more scribly texture. It works great.

Jen