Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Stihl MS290 Recommendation

Posts

Stihl MS290 Recommendation

#1

Stihl MS290 Recommendation

David Breth

>Ran into a guy yesterday with a Stihl MS290 that he is selling. He wants $100, maybe I could get him at $80, you never know.

The condition is ok, it does have some rusty spots on the bottom, and shows some use, or in his words "I probably only used it a dozen times" (believe what you like). Says he has not started it this year/had trouble starting it this year, recommends cleaning the spark plub. Has had trouble-free service from it, but is moving into an apartment, etc. I can believe he is moving into an apartment based on where he works, but beyond that who knows what reality is.

He removed the original chain/bar and put on an 18" bar, which is interesting.

My questions are therefore these:

1) Is he overworking the engine putting the larger bar on it?

2) Given the circumstances, I think if it could be had for $80, it might be worth the flyer to replace my crapstman from Sears. But, I don't have $80-100 to toss around for fun. Whattya think of this?

Thanks very much - and have a great 4th! Remember, 1776 is playingon TCM tonight!!!!

David B.

Re: Stihl MS290 Recommendation

#2

Bob Moffett

Re: Stihl MS290 Recommendation

Bob Moffett

>I have a Stihl 290 with an 18" bar and have had no problems with it. You may want to have a chainsaw mechanic look at it to see if the motor is in good condition.

Re: Stihl MS290 Recommendation

#3

Re: Stihl MS290 Recommendation

Cyril Griesbach

>Dave,

I have two of these saws. They are call the "Farm Boss" and for good reason. One of them is old enough to have the old model #of 029 and both have 20" bars. I've had no problems with either of them other than keeping fresh gas in them and the replacement of one fuel filter. Please note that sharp chains do work so that the motor doesn't have to work so hard. Each of my saws run more than 20 hrs a year "in wood". If the saw you're looking at is hard to start put fresh gas in it and you'll probably have a runner. Hopefully the seller didn't run it without the proper fuel/oil mixture. I'd say the $80 - $100 is a good deal.

Re: Stihl MS290 Recommendation

#4

Re: Stihl MS290 Recommendation

Carole Valentine

>I have a 250 with an 18" bar. No problems at all. The recommended guide bar lengths for the MS 290 are 16" to 20".

Re: Stihl MS290 Recommendation

#5

Re: Stihl MS290 Recommendation

Gary Evans Tallassee, TN

>Hi David,

I also have two MS290's. One I bought for myself because it was cheaper and claimed more HP than the comparable Husky. The second I bought for my late son because I liked mine so well.

I would remove the spark plug and crank it over a few times with my thumb over the hole. If it has enough compression that you can't force your thumb to stay in place, then it's well worth $100. It will be 3 or 4 times the saw you have now. It also wouldn't hurt to hold the plug against the cylinder and make sure that it makes some spark.

By the way, both mine came with 18" bars, and sold new for right at $400 out the door.

Gary

Re: Stihl MS290 Recommendation

#6

Re: Stihl MS290 Recommendation

Curt Fuller

>My ms 290 came with an 18" bar and in handles it just fine. That sounds like a deal I wouldn't pass up. I've had mine for about 5 years now and have cut mountains of wood with no problems. Keep the chain sharp. Life is too short to struggle with a dull saw.

Re: Stihl MS290 Recommendation

#7

Re: Stihl MS290 Recommendation

Ken Grunke from SW WI

>I would be more comfortable with a saw that was used regularly, and maintained well. A saw that's loved and used wouldn't have rust on the bottom. Was it sitting in water, or what? I'd say if he doesn't accept your $80 then forget about it.

If you end up getting it, check the exhaust screen which can cause poor running. That valuable tidbit of info I recieved here on Woodcentral last year.

Re: Stihl MS290 Recommendation

#8

Re: Stihl MS290 Recommendation

Robert D. Macgregor

>Also check that the air filter is clean. In addition, if the saw hasn't been used in a long time and was stored fueled, the carb might need a rework/cleaning (this happened to my Stihl 026 once a number of years ago). Most of these are fairly minor maintenance concerns; as long as it has good compression and a spark the rest can be cleaned and tweaked.

Re: Stihl MS290 Recommendation

#9

Re: Stihl MS290 Recommendation

jared

>I would buy it at either $80 or $100 in a minute. Stihl holds its resale very well. And if for some reason it is complete junk/unrepairable you can ebay it and probably get your purchase price back out of it. I did that with a 30 year old john deere, made by echo this winter. It didnt run, would have taken at least $100 of electronic ignition parts to fix it so I listed it and got nearly $50 out of it and used that along with the $100 I saved in parts to buy a Stihl 390 that cuts like you you wouldnt believe. Jared

Re: Stihl MS290 Recommendation

#10

Re: Stihl MS290 Recommendation

David Breth

>Thanks for the recommendations, everybody. I called the guy back and oooops, it was sold.

Guess I'll know better next time.

Thanks once again!

David B.