Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

JET 1236 Owners - Help Please...

Posts

JET 1236 Owners - Help Please...

#1

JET 1236 Owners - Help Please...

Steve Russell

>Hello,

If you have a JET 1236 lathe, would you please help me to answer a couple of questions regarding your lathe...

1.) What is the distance from the top of the banjo (without the toolrest installed) to the centre of the spindle? This measurement should be taken from the highest point on the banjo where you install the toolrest, to the centre of the MT spindle hole.

2.) What is the diameter of the tool rest post where it inserts into the banjo?

I'm working on making an adapter for a tool holder and need these dimensions. I appreciate any help you can offer. Take care and all the best to you and yours!

Steve Russell

EWW, WVP

The Woodlands, Texas

Re: JET 1236 Owners - Help Please...

#2

Re: JET 1236 Owners - Help Please...

Mike Hamilton

>One inch post. 3.5 inches from machined top of banjo to center of spur drive.

Regards,

Mike Hamilton

Plainfield, IN

(the fact I can get this for you, means I'm set up and turning this weekend, woo hoo)

Re: JET 1236 Owners - Help Please...

#3

Re: JET 1236 Owners - Help Please...

Ken Grunke from SW WI

>Just to verify Mike's measurement of 3 1/2" from top of banjo where the 1" toolpost goes into, to the spindle center.

Re: JET 1236 Owners - Help Please...

#4

Re: JET 1236 Owners - Help Please...

Steve Russell

>Hello Mike and Ken,

Thanks so much for your help on this! I sincerely appreciate your post and the information. Take care and all the best to you and yours!

Steve Russell

EWW, WVP

The Woodlands, Texas