Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

question qabout oil-hardened steel

Posts

question qabout oil-hardened steel

#1

question qabout oil-hardened steel

eliot d

>Is oil hardened drill rod already hardened? ( I would think so.) But a guy I know thinks it's TO BE oil hardened; i.e. it's not hardened yet but is of a composition so that it can oil hardened.

Re: question qabout oil-hardened steel

#2

Re: "guy I know" is right. It's dead soft.

Al Crandall (N.E. of Indy)

>

Re: question qabout oil-hardened steel

#3

Re: It is not pre-hardened,...

Allen Neighbors

>but it is harder than a Oneway Toolrest (I don't know what sort of steel it's made of). I used O-1 1/4" rod to edge my toolrests, and it doesn't nick as bad as the toolrest did.

If you want it hardened, you need to order it that way. If you try to harden it, it will warp out of shape.

Re: question qabout oil-hardened steel

#4

Richard Allen

Re: question qabout oil-hardened steel

Richard Allen

>O-1 steel is High Carbon Steel which can be hardened with a MAP gas torch. Heat to red hot and use oil to quench the steel. Once cool you need to temper the steel (soften it a little) buy heating the steel. Watch for a "straw" color as you heat the hardened steel. You can also send the steel out to a service for hardening and tempering. You should do any and all machining on the soft steel first. You will have to work hard to shape the hardened steel. You can also remove the temper from HCS if you try to shape the hardened steel.

HCS tools are often heat treated only at the cutting edge. When you grind past the hardening you shape and then re-harden the the new cutting edge.

To test if steel is hardened run a file over it. If the file "bites" it is annealed (soft). If the file skips across the steel it is hardened.

Re: question qabout oil-hardened steel

#5

Hey! I'm that guy.

Bob Stroman

>