Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Rebuilding Post Turning Lathe

Posts

Rebuilding Post Turning Lathe

#1

Rebuilding Post Turning Lathe

Ron Bauman

>Nearly 20 yrs ago I acquired the head and tailstock of a circa 1890 post turning lathe. I rebuilt and turned the wooden pulleys which were damaged and made a jack-shaft driven by an electric motor. There still was (and is) a place that made flat belts. For reasons I don't remember, I sold the lathe to a friend who moved to New Mexico. A couple of months ago I found I needed a lathe with large capacity to true and dish my line of stools known as "The Big Keester". (the seats are 15-16" across and 2" thick) I thought of the NM lathe and emailed my friend. He still had it and had never used it and stored it in a leaky shed. "Sure, you can have it back, but the pulleys look grim." As per the pics you can see that the pulleys have delaminated. However, never one to admit defeat, I've deconstructed the whole mess and begun to rebuild. I'm just going to use the headstock with a face-plate and the tail can become ballast. I'm using White Oak 4"x6"s to build a frame to hold the machine. If there is any interest I'll post pics from time to time as the project goes on. I know there's probably a spot at OWWM, but that is not my real interest and I'll be using this in a contemporary situation. The consideration was money, and I think I can redo this hummer for under a grand not considering my time. Anyhow, that's my story and I'm sticking to it. Let me know what you think...


img

Re: Rebuilding Post Turning Lathe

#2

Do you have a website for your stools?

Eddie Pacheco, San Jose, Ca.

>

Re: Rebuilding Post Turning Lathe

#3

Uh, --- I mean your wooden sitting stools.

Eddie Pacheco, San Jose, Ca.

>When you see something in print it sure looks a lot different than what was in your mind.

Re: Rebuilding Post Turning Lathe

#4

Re: Uh, --- I mean your wooden sitting stools.

Ken Oakley-Sunny St. Cloud, Fla.

>You know what was on my mind, I'll bet-----

Re: Rebuilding Post Turning Lathe

#5

Yup,

Eddie Pacheco, San Jose, Ca.

>The minute I posted it and read it, I knew you were gonna be all over it link stink on ________

You're always quick to spot the misworded post.

Take care and have a nice weekend, Ken.

Re: Rebuilding Post Turning Lathe

#6

Re: Yup,

Ron Bauman

>I do, but it's in the very early stages of developement and quite unprofessional at this point. However, here it is http://www.fieldmousews.com/index.html

Re: Rebuilding Post Turning Lathe

#7

Ken and I are the two most unprofessional,

Eddie Pacheco, San Jose, Ca.

>guys on this website! Thanks for the info.

Re: Rebuilding Post Turning Lathe

#8

Re: Ken and I are the two most unprofessional,

Ken Oakley-Sunny St. Cloud, Fla.

>Do we get a hat or tee shirt for that accomplishment?

Re: Rebuilding Post Turning Lathe

#9

The stool award!

tek-Brunswick, Ohio

>

Re: Rebuilding Post Turning Lathe

#10

Re: The stool award!

tek-Brunswick, Ohio

>Bachelor of Stools award that is. You, know. The Old B.S. award.