Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Streaking Walnut

Posts

Streaking Walnut

#1

Streaking Walnut

RP

>I've never used sanding sealer before. I bought some water based sealer at Lowes. It says you can put poly on it after it dries. I turned two walnut bowls. I lightly sanded them after the sealer was dry and applied poly over it. I got dark and light streaks and shiny and dull spots. I don't think I sanded through the sealer. I used steel wool primarily 0000 and lightly at that.

I feel I stirred the sealer pretty good. I tried to make sure the solids were suspended and uniform color.

It has done this twice to me now. I wonder what I'm doing wrong.

RP

Re: Streaking Walnut

#2

Richard Allen

Re: Streaking Walnut

Richard Allen

>Walnut is an open grain wood. Sanding sealer is a good idea to help build up a finish. Two or perhaps even three coats may be needed to fill the grain of an open grain wood like walnut.

You should be able to tell what parts didn't get enough finish after sanding. You should clean off the sanding dust between coats. Wiping the the surface with a paper towel dampened with lacquer thinner will remove the sanding dust and show the shinny and dull areas.

If you don't want to put more than one coat of sanding sealer on the object. Sanding sealer tends to "cloud" the color of the wood more than a gloss finish coat. You can apply additional coats of the poly finish to get the even shine you are looking for.

Re: Streaking Walnut

#3

Ric Taylor

Re: Streaking Walnut

Ric Taylor

>RP,

The sanding sealer I use is the celulose type from Myland's. I think most of us use sanding sealer primarily to fill pores in the wood. When I put it on, I sand it down to the bare wood. I do that between each grit of sanding, i.e. 120, sanding sealer, 180, sanding sealer, 240, sanding sealer, etc. etc., sanding to bare wood each time. This results in a very smooth sometimes glassy final surface.

Sometimes after doing this I will use my buffing wheel system to buff the wood resulting in a glassy finish without adding any other type of funish.

It sounds to me like you may have sanded to bare wood in some areas, and left sanding sealer in other areas, resulting in your uneven final finish.

Ric

Re: Streaking Walnut

#4

Don't Look Ethyl!

TDaniel

>I couldn't help it. :)

Re: Streaking Walnut

#5

Re: Streaking Walnut

Bill McWhirter

>If you are using any type of water based finish, you should probably avoid steel wool. I have been told that small fibers can get left on the surface and rust with subsequent coats.

Re: Streaking Walnut

#6

Re: LOL!!! That came to my mind, too!

Allen Neighbors

>

Re: Streaking Walnut

#7

Re: Streaking Walnut

georgetroy

>My advice is change what you did. I use Deft Clear Wood Finish for a sealer or you can do several coats. Over that will go your favorite Tung Oil finish. Water base finishes is for the places that can not stand the odor of the lacquer or oils. GT

Re: Streaking Walnut

#8

Thanks for the mental image, TD!! LOL

Ruth Niles

>