Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

How to drill a small hole with a big bit

Posts

How to drill a small hole with a big bit

#1

How to drill a small hole with a big bit

Jim Shewan

>This is a vase I turned out of green goarse, I knew there would be some shrinkage but it was much more than I expected. The bit pictured is the one I used to start the hollowing and now the hole is much smaller.

I had originaly intended to clean up the foot when it dried but decided to leave it rough to show off the shrinkage split.

There was far less spliting where the walls had been turned thin and I repaired the crack up from the base with CA and sanding dust.

Not so noticable in this pic is the nice "leening tower" look it has now.


img

Re: How to drill a small hole with a big bit

#2

Re: How to drill a small hole with a big bit

Ken Grunke from SW WI

>You fellows down under have all sorts of weird wood, with interesting names. I wonder if there are counterparts in the North American continent, or if our woods and yours are just different from each other?

This wood seems to be highly reactive when drying. Probably has a high rate of tangential shrinkage, which accounts for the drastic reduction in hole size. I turn flower vases from branches with a 1/2" (12mm) hole through the pith for glass tubes, and the hole often ends up 25% smaller . Of course I have to make sure they are dry before being sold or given away or there will be shards of glass stuck in the center.

Recenty, someone was asking to find a wood that did weird things when drying but I can't remember who or on what forum. Maybe this would have satisfied them.

Re: How to drill a small hole with a big bit

#3

Re: How to drill a small hole with a big bit

robo hippy

>Leave the hole the way it is to go along with the warped look, unless it is intended for a test tube so you can put water in it for live flowers. If you are going to drill it out, use a brad point bit rather than the twist bit you are showing. I would expect the twist bit to grab and shred the opening of your vessel.

robo hippy

Re: How to drill a small hole with a big bit

#4

Re: How to drill a small hole with a big bit

Jim Shewan

>The bit is there to illustrate shrinkage only. It was the one I used initialy to bore a hole. the hollowing has been completed to 3/16th-1/4.

The goarse I used is a prickly srub imported from the UK buy some of the original settlers of NZ.

It was to be used as hedgrows for fenceing stock but quickly became one of NZ's worst weeds, covering thousands of acres of hill country.

The pic is my tractor in a patch at the back which I was spaying.


img

Re: How to drill a small hole with a big bit

#5

Re: NZ weeds...

Allen Neighbors

>Jim, I wish it wasn't so far to NZ... I surely would like to see that beautiful countryside! Goarse looks like our Salt Cedar that grows like weeds here in NW Texas.