Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Small issue with SN2 chuck

Posts

Small issue with SN2 chuck

#1

Steve Kubien

Small issue with SN2 chuck

Steve Kubien

>Morning everyone,

I bought a second-hand SN2 as part of a package to get a one month old Nova 1624 and I have a question....

Is there a way to allow the jaw slides to extend past the body of the chuck? On my Nova midi chuck, I never installed the screw which limits jaw travel. Therefore, I have a MUCH greater range of tenon sizes and recesses I could create without going to other jaws on the midi. I am fully aware that I run the risk of badly bashing my knuckles if I can do this. Is there a grub/set screw somewhere that I cannot see?

Thanks for your help,

Steve Kubien

Ajax, Ontario

Re: Small issue with SN2 chuck

#2

Re: Steve, I dismantled my SN2s...

Allen Neighbors

>to clean and lubricate them, and I didn't find any screw that would eliminate jaw travel. If I remember right, what I did find was that one or more of the jaw slides were not grooved such that the pinion(?) could screw them out farther. I thought about using my dremel to make the groove so they would extend farther out. I didn't do that because I was afraid I might mess something up. I've wished more than once that they would open further just an 1/8 of an inch. So now I am more careful about the sizing of the tenons. :)

Re: Small issue with SN2 chuck

#3

Re: PS: I think that...

Allen Neighbors

>the SN2 is an awesome chuck. This little drawback isn't really a drawback.

Re: Small issue with SN2 chuck

#4

Re: PS: I think that...

John Gornall

>I'm dissappointed in my SN2 chuck. The problem is rust. I chucked a piece of green wood and worked on it over 3 days. When I removed it from the chuck to turn it around the jaws were completely rusted and the wood blank was stained black. I had to cut a lot of wood off and redesign the project. My Oneway jaws don't rust.

Re: Small issue with SN2 chuck

#5

Grizzly vicmarc copy rusts also

john lucas

>I left an Oak blank in the chuck overnight. I know better but I had a brain fart. It rusted the jaws of my Grizzly chuck. I haven't had that problem with the Vicmarc but I don't think I've left anything as acidic as Green oak in them either.

Re: Small issue with SN2 chuck

#6

Re: PS: I think that...

robert davis

>my oneway talon does rust..had to take i apart to clean

Re: Small issue with SN2 chuck

#7

Re: Make Rusty plans... so to speak.

Allen Neighbors

>Since I found out that my SN2 jaws will rust, I've developed a routine of sorts.

If I know that the piece will be in the jaws for a day or two, I make sure I have enough wood to waste near the jaws. I also have a brass bristle brush that I clean the jaws with when I take the piece out. And if that's not enough, I remove the jaws and put them into a small jar of Lacquer Thinner for a while... it makes them easier to clean.

This is the only problem with SN2s...other than that, they're perfect!

Re: Small issue with SN2 chuck

#8

Dick Hines

Re: PS: I think that...

Dick Hines

>Most any metal will rust after getting wet.

I wonder why you would leave a piece of wet wood in a chuck for 3 days? I try to turn wet wood as fast as I can and the shoot my chucks with WD40. Alnog with CA glue it's one of a wood turners friends.