>Jim, I really like your new direction. These pens are spectacular! The chrome (assumed) finish combined with the black and white are a stunning combination. The recessed clip tops it all off.
I can't wait to see more of these pens as you continue to work in this direction.
I have seen other recessed clip methods where the top is sliced off, barrel notched, clip added then the top glued back on... leaving an obvious glue line.
Your pens show absolutely no indication of how you recessed the clips! Care to share just how you accomplished such a flawless execution of a recessed clip?
Keith the HW is actually black titanium, hard to tell from the images actually.
I like the Keep It Simple design right now, I think that there is a simple flow in these pens that will make them comfortable to use and probably my keepers.
I think you have a winner here! Have you looked into Rich's methods of turning the section out of your own material? I bet they'd look good with the section turned out of black acrylic!
If you produced these in a fountain pen, I bet you could do do a limited edition run of a hundred pens, start your own pen company, and sell these for about $900 a piece!
Your job recessing the clip looks real neat! Dang, the whole thing looks real neat! Very impressive!
Thanks for your kind and thoughful support, your advice and guidance to me over the years has always been an inspiration in helping my pen making improve.
I am not sure I have seen Rich's method, could you share a link?
I sent you an email, when you have time ..
Thanks again, I have a hundred pens to make, $900, hmmm, I like that deal, eh!
>Thanks for showning these pens, Jim. The white and black makes an elegant combination, and easilly adds another $100 to the price of the pen.
Anyone who is at the AAW Symposium in Portland, come and see my presentation on how these can be done. If you can't be there, I will have a video available after the Symposium, and also for sale at the Symposium. The video shows several ways to do this. Recessing the clip really isn't that difficult to do, and there are many possable combinations of clips and kits. We can even use the clip that came with the kit.
On the value of the pen, you will need to do a couple things before it will be a $900 pen. You will have to get rid of the kit nib, and get one of the 14k or 18k solid gold nibs that are being imported. There is no way that anyone is going to pay $900 for a pen with the stiff plated steel $4 nib that came with the kit. In fact, there is no way anyone will pay over %200 for a pen with the kit nib, regardless of how nice it is, unless you find a sucker.
Another suggestion is to get rid of the plated grip area from the kit. You can either tear that one apart, or use the same nib that is available for the Ameroclassic, and similar pens. It screws right into the Baron fittings, and being plastic is easilly turned down and covered with a piece of the ivory. Add the gold nib when you put it back together.
Even if you don't cover it up, the black plastic of the Ameroclassic nib is a better choice for a writing pen. Besides being available in a wide variety of widths from fine to a braod calligraphy tip, it will wear better because it stays black, and all plating on the metal grip will wear off over time. You might also consider that the black will add to the appearance of the pen.