Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Bandsaw Motor Power Loss

Posts

Bandsaw Motor Power Loss

#1

Bandsaw Motor Power Loss

Dave Winters

>Dumb Question-

Seems like my Bandsaw (Laguna LT-18) motor is more and more gutless. Takes longer to get up to speed with no load and loses power easier when sawing under load esp. sawing thick and/or wet stock, even with a fresh new blade.I do have a fair number of hours on it.

I guess my question(s)are: does a motor lose power like this before total burnout? Should I upgrade to a bigger, badder motor? Three phase is not an option. Recommendations? Laguna is hideoulsly expensive on parts in my experience.

Thanks in advance...

Post Response Return to Index Read Prev Msg

Re: Bandsaw Motor Power Loss

#2

Re: Bandsaw Motor Power Loss

Dennis Yoder

>Dave, I am assuming that you have checked the motor and drive pullies for loss of key in key way, loose set screws, glazed belts,loose tires on the large wheels, squeeling bearings, etc. The motor can usually be rebuilt instead of replaced. Granger should have replacement motors or use the web to find the same or more powerful motor. Dennis Y

Re: Bandsaw Motor Power Loss

#3

Re: Bandsaw Motor Power Loss

Dave Winters

>No, haven't checked all that stuff, I'll check it tonight, Thanks.

Re: Bandsaw Motor Power Loss

#4

Re: Bandsaw Motor Power Loss

Ken Oakley-Sunny St. Cloud, Fla.

>Possibly the capicators, start and running , are giving up the ghost.

Re: Bandsaw Motor Power Loss

#5

Re: Dave- I'm no electrical expert, but...

Jamie Donaldson

>.. it sounds like you have lost 1 leg of your 220 v power, assuming it is 220 v. I had a similar problem with a lathe years ago- get out the volt meter.

Re: Bandsaw Motor Power Loss

#6

Re: Bandsaw Motor Power Loss

Steve Russell

>Hello Dave,

I had the same problem with my LT-18 not long ago, it ended up being a bad belt. I tried replacing it with a link belt, but the link belts were not up to the task. I used a factory belt replacement (metric belt) and now I'm standing in Tall Cotton! The old girl is purring like a kitten and cutting like it's brand new.

A few years ago I had a bad capacitor as well and replaced that... However, the motor would not run at all then, it just hummed. If you have the original belt on the saw and it's more than 7 years old, I would look there first. Good luck to you and best wishes in all of your woodturning endeavors!

Steve Russell

The Woodlands, Texas

Re: Bandsaw Motor Power Loss

#7

Re: Bandsaw Motor Power Loss

Dave Winters

>It was the belt... just needed tightening. It's still "fluttering" at speed.. should I tighten more till that goes away?

Thanks all for the responses.

Now I have another HUGE issue.. I'll do another post on that.