Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Redoing a pen finish - years later

Posts

Redoing a pen finish - years later

#1

Redoing a pen finish - years later

Marianne

>A co-worker has a favorite wooden pen and all the finish is pretty much gone. He asked if there was a way to restore the finish. I don't know if the pen parts are glued in or just pressed in. Any suggestions?

Re: Redoing a pen finish - years later

#2

If you are careful

Terry Quiram, Roanoke Illinois

>you could probably use a wipe on finish. It wouldn't look quite the same but it would look better. The pen parts are pressed together and don't come apart easily.

Terry

Re: Redoing a pen finish - years later

#3

Re: If you are careful

Tony - Memphis

>I've done that. I took the pen apart and taped over the metal parts. It worked quite well. Make sure you prepare it well. I probably has some wax and of course skin oil on it.

Tony

Re: Redoing a pen finish - years later

#4

Re: Redoing a pen finish - years later

Jim Shaver - Oakville, Ontario

>Hi,

Terry and Tony have offered great options in doing this.

The way I do this is different though. There are some pen disassembly kits out there and I use them to make repairs when needing to take pens apart. If you used one you could knock out the hardware and put the pen bodies back on the bushings and refinish.

I have done this with no problems. If the hardware fits loosly I have put a drop of CA on the inside of the pen (tube) then press the parts back together.

Take care,

Jim

Re: Redoing a pen finish - years later

#5

Thank you for the advice!

Marianne

>First - thank you all for responding and all the advice was great! Given that I didn't make this pen I'm a bit hesitant to try and pull it apart only because if I render the pen unusable I'll feel pretty bad. Usually I mess up my pen making waaaay before it ever gets put together successfully! I think for this case if my co-worker wants me to, I will go with the prepping wood, protect the metal components and apply a wipe on finish. Thank you all again for taking the time to respond. Marianne