Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Check Filling

Posts

Check Filling

#1

Check Filling

Mark Mandell - Gone Round In Jersey

>I'm starting a full-log end-grain piece (18" blank) in Box Elder that has a pith crack along the entire length. I plan on filling the crack, but am wondering when it would be better to do so; before or after I hollow. It's not the only "defect" as the wood has a bunch of hairline fractures that look very cool when finished (if I get it off the lathe without it exploding, that is). The stuff is a bit fragile so I'm wondering if anyone here has tried this and does the different density of the filler effect the cutter too much?

I may wind up taping the outside for added strength during the cut.

Thanks

mm

Re: Check Filling

#2

Steven Antonucci

Pros and cons to either way

steve antonucci

>If you are turning real thin, the hardness of the fill might matter, since it will cause a "tick" where the fill is, but it really isn't so bad.

Tape will help keep the vessel from expanding, but not compressing. If you fill the voids first, it should help it in compression. The tradeoff is that sanding becomes much harder to do since the fill is much harder than the wood around it.

If you wanted to do it "perfect", here's my recipe- turn the outside and sand. Then add finish of choice. Then fill. then sand fill and finish. Then tape and hollow.

Lot of work, but best results. Me? I'd just CA and sawdust the crack and go from there...

Steve

Re: Check Filling

#3

Re: Sand & finish

Mark Mandell - Gone Round In Jersey

>Piece has been sanded to 150 and I was planning on giving it a coat of shellec before filling the cracks to prevent the filler from staining the surrounding wood. Think I'll use epoxy with Bordeaux Transtint. Finished piece will be about 14" tall so I plan on about 3/16" thickness.

Thanks

mm

Re: Check Filling

#4

Re: Sand & finish

Allen Neighbors

>I do things the way Steve explained... for me, it is the best way. If you finish the outside, to include the filler, it will be much easier to hollow... with the exception of the filler being harder than the wood when you get to it when hollowing.

I have some cutters that are harder than M2 HSS that I use for cutting filler such as turquoise stone.

I also would put some sort of finish on the wood before the filler.

Re: Check Filling

#5

Thanks, Allen & Steve

Mark Mandell - Gone Round In Jersey

>I get my cutter stock from ENCO with 10% cobalt that puts them well above the HSS and M2 classification. While I decided not to completely finish the exterior, I have applied 2 coats of dewaxed ultra blond and am adding the die to the epoxy I'll need for the crack fill. Decided to leave the plastic pure rather than mix in a aggregate. The split's only 3/16" at its widest, and my mix is a fair reflection of the "natural" ambrosia staining in the wood. When the epoxy sets up I'll relevel the surface and then band with tape before I dive into the Interior.

Finally get to use my SpinDoctor steady rest.

Re: Check Filling

#6

Re: Thanks, Allen & Steve

Allen Neighbors

>Those Enco cutters are the same that I use, too, Mark. They're sure better than M2.

Speaking of the SpinDoctor, I've been by his place in OKC twice to see him and his hollowing rig, and he wasn't home either time. My Son lives just 9 blocks from him. I've also emailed him, and didn't get an answer. Maybe one day I'll catch him there. That's got to be an awesome rig!

Re: Check Filling

#7

SpinDoc

Mark Mandell - Gone Round In Jersey

>I have a steady rest only. I made my own hollowing rig.

mm