Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

free standing tool rest

Posts

free standing tool rest

#1

free standing tool rest

John Pickett

>I am thinking about trying to make or acquire a free standing tool rest. I know there are some effective homemade rests out there. Anybody here have one (I hear that John Lucas made one). Pictures please :)

Re: free standing tool rest

#2

Re: free standing tool rest

John Lucas

>John I'll post photos of mine tonight after my bike ride.

Re: free standing tool rest

#3

here's the photo

john lucas

>Here's my tool rest. It needs more weight. I used a truck wheel and added a 3/4" by 6" piece of steel over the center hole and then use pipe and Pipe fittings to finish it off. I put some leveling feet. I think I'm going to pour concrete in the wheel to make it heavier.

It's just light enough that if you don't have absolutely perfect tool control it pulls the tool rest into the work, or at least causes some vibration which makes clean cuts difficult. It would work well with a scraper.

I'm also thinking about making a sort of hinged elbow that attaches to the lathe and goes to the tool rest pole. This is similar to the Vicmarc free standing tool rest. I think it would add a tremendous amount of rigidity to the tools rest.


img

Re: free standing tool rest

#4

Re: here's the photo

John Pickett

>Thanks, John

Re: free standing tool rest

#5

Steven Antonucci

Here is my version

steve antonucci

>My headstock can rotate, so I made this out of some leftover 2x stock and blackpipe. cost about $12

Since the toolrest inserts into the regular banjo and the freestanding leg only holds up the end of the bar, it's pretty stable. (doesn't tip) I could rebuild it much "beefier" if I wanted too, but it works well enough as is.

The base is a simple X screwed into the bottom. I filled it the blackpipe with sand to dampen the vibrations, and sealed the end with a wooden plug that I hammered in. For scale, the platter on my Nova is 23" across.

Steven


img

Re: free standing tool rest

#6

Re: here's the photo

John Pickett

>Does this bolt onto the floor? it looks like there are bolts.

Re: free standing tool rest

#7

Re: Here is my version

John Pickett

>Thanks. And no welding. Even I could do that! :)

Re: free standing tool rest

#8

Re: here's the photo

john lucas

>No, you need to be able to move it around for different cuts and shapes. If you can find a photo of the Vicmarc outboard turning rest you will see what I think is the best design for "free standing tools rests"

Re: free standing tool rest

#9

Re: here's the photo

John Pickett

>That's what I thought, so I was confused when I thought I saw Bolts on the base. Thanks for the clarification