Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Hollow Form

Posts

Hollow Form

#1

Hollow Form

Don Tewell

>Sorry, it would help if I added the actual photo.


img

Re: Hollow Form

#2

Steven Antonucci

Some suggestions

steve antonucci

>I think that you've done a fine job with finishing, but the form could use some help. The bottom has a "flower pot" feel to it, and the top goes somewhat flat at the top of an otherwise pleasing curve.

When you begin your turning, plan out the form and try to stick to the basic design. If something unplanned happens and you are force to redesign, consider reducing the scale of the project vs. the shape, since you may not be able to reshape without these types of issues.

In the event that rescaling or reshaping doesn't seem feasible, take the piece off the lathe and move on. I have a huge shelf full of things that are waiting for another day on the lathe or the fireplace- but I won't spend a lot of time on them if they can't be "fixed".

If you read the thread below about tool vs. form, you'll see a lot of conversation about this.

Steven