Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Repaired Goblet

Posts

Repaired Goblet

#1

Repaired Goblet

Curt Fuller

>A while back I took a goblet with a segmented type celtic knot to our turning club and they asked if I would demo how to do it. So I glued up the wood and got all ready to do it last thursday. I get pretty nervous when I have to do something like that so I was pretty rattled. Things weren't going too bad and then I got to the skinny section of the stem and hit a spot in the wood where there was a void that I didn't know was in there. The stem broke and that was pretty much the end of the demo. I had a spare piece of wood but not enough time to start over. Pretty embarrassing to say the least. Anyway, I brought the pieces home and did a salvage job on it today. The cup is ash with wenge for the celtic ring design. I made a base from the ash, drilled a small hole in it and the base of the cup and made a new stem from wenge. 7" tall by 1.75" dia. Deft lacquer finish.


img

Re: Repaired Goblet

#2

Re: Repaired Goblet

RevDoug

>Pretty nice save. I enjoy most everything with celtic knots. Nicely done.

Turn 'em round,

Re: Repaired Goblet

#3

Re: Repaired Goblet

Wayne Leach-NW Ontario

>What a great job on saving the goblet, it looks way too nice to have used it for firewood,. Keep up the grest work.

Wayne

Re: Repaired Goblet

#4

Re: Repaired Goblet

adrien

>Very nice save. Any chance of an article on the glue-up for a Celtic knot?

Re: Repaired Goblet

#5

Re: Repaired Goblet

Curt Fuller

>I'm not sure how to do an article but here are a few pictures that might help. The first shows how the first cut is made. This one is cut at a 25 degree angle. The piece of wood that is glued in to make each ring of the celtic knot should be the same thickness as the saw kerf, usually 1/8". After you've glued it, turn it over to the next side and repeat the process. The second picture shows it with 3 sides done and the fourth cut and ready to glue. The last picture is the end result and ready to turn the goblet. I hope that helps, I'm not much at instructions.


img

Re: Repaired Goblet

#6

Great! Thank you.

adrien

>

Re: Repaired Goblet

#7

Re: Repaired Goblet

Don in Central Illinois

>That is great. It is simple enough I may even try it. Goblet look great and better save.