Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Maintaining a round tool rest?

Posts

Maintaining a round tool rest?

#1

Maintaining a round tool rest?

Stuart Johnson

>I thought I would start a new thread rather than hijacking the which tool rest one.

I'm not understanding the way to handle nicks and dings caused by catches. It seems if you file the nick flat you will create a dip in the round bar. Do you file the entire length of the bar when taking out the nick? Wouldn't this then cause a flat in the bar and then another when you repair the next one. If this is the case after a bit you would have a pretty beat up tool rest. I'm fairly certain this isn't case but would like to know how they are handled.

Re: Maintaining a round tool rest?

#2

Re: Maintaining a round tool rest?

John Lucas

>Bill These are usually really small nick. Ideally you should round over the edges of tools like parting tools and flat scrapers so that they don't ding the rest. Most of the time it only takes a swipe or two across the rest to make it smooth enough for tools to glide across it. Don't use a big 12" bastard file, all it takes is maybe a 6" or so with tiny teeth. I've had my round tool rest for at least 6 years maybe more. I can't tell that I've done anything to it other than it just looks dirty.

Re: Maintaining a round tool rest?

#3

Poi-sonal-ly

Mark Mandell - Gone Round In Jersey

>I just file the few blemishes on the rest until the high edges of the nick are gone. Tool seems to run fine. If you use steel (rod or plate) rather that cast rests, you can heat treat the rest to a high Rockwell value that will resist the dents to begin with.

If course, I don't have much of a problem 'cause I don't get catches so what I do is of limited application for others. |;-}}}}}}

mm

Re: Maintaining a round tool rest?

#4

Re: Maintaining a round tool rest?

Wilford Bickel

>I made my own round tool rests and in researching before welding them up I found out that if you use Cold Roll steel it is hard enough it is very resistant to knicks. If you use hot roll steel it is much softer and it will nick badly. I don't remember where all I found this info but I made mine out of Cold Roll and have never had to worry about a knick in the tool rest. I have to sand off CA and finish at times with some fine grit sand paper and recoat with rust preventer but that is all I have done in several years of use.