Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Maple gone bad

Posts

Maple gone bad

#1

Maple gone bad

John in MD

>Finally got around to cutting up a section of trunk from a Silver maple my neighbor took down last year. I liberated a couple of larger trunk sections, hoping to use them for lathe practice.

Looks like maybe I waited too long to cut the logs up into turning blanks. The wood is still solid, but has all this discoloration and streaking. I guess it went bad (like that bologna I found in the fridge).

Too bad. Hate to see good wood go bad like this. I was hoping to get a nice platter or maybe a bowl out of some of the larger trunk sections...

Seriously, I just wanted to gloat about the spalting I found when I finally split one of these rounds. Can't wait to try to make something pretty out of it.

Any suggestions for finishes?

Thanks.

-John-


img

Re: Maple gone bad

#2

Re: Maple gone bad

Bart Rhoads

>One thing to keep in mind when you select a finish is that any oil finishes will have a tendency to darken the wood some what where as your laquers and polyeurthanes will darken some but not near as much. The water base polys are more clear than any I have used.

.

Re: Maple gone bad

#3

Re: Maple gone bad

Barry Turner

>Yeah, that stuff is definitely bad! Just stack it out by the street and we will properly dispose of it for you.

Re: Maple gone bad

#4

Steve Kubien

Re: Maple gone bad

Steve Kubien

>Too bad about the lost wood. Really, my heart bleeds for you. I have only done one piece in spalted maple and I used lacquer on it. It is probably my favourite finishing job I have done.

FWIW

Steve Kubien

Ajax, Ontario

Re: Maple gone bad

#5

Re: Maple gone bad

George Van

>John, I have had good luck using thinned 50/50 lacquer and thinner for a sealer coat after sanding. I then wipe on as many coats of oil/varnish coats as i deem necessary for the finish sheen required.

Re: Maple gone bad

#6

Thanks for the replies

John in MD

>Thanks all -

I will probably try the laquer/thinner mix as a sealant, followed by unthinned laquer.

Hope to be able to get some lathe time in the next 2 weeks, so I'll post a photo for critique later this month.

Many thanks for the replies, and finishing recommendations.

-JOhn-

Re: Maple gone bad

#7

Re: Maple gone bad *LINK*

Darrell Feltmate

>Nice spalt. I was asked what we do to get spalted maple in Nova Scotia and my reply was to get too busy to turn :-) I like to use a thinned varnish on spalted wood and lots of other timber as well. It soaks in well the first couple of times and really pops the spalt lines. I do not really measure it, just thin maybe 20 percent or so.


Around the Woods