Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Fine Woodworking.com, Lathe Article & Video Links

Posts

Fine Woodworking.com, Lathe Article & Video Links

#1

Andy DiPietro

Fine Woodworking.com, Lathe Article & Video Links

Andy DiPietro

>FYI

Tool Test: Heavy-Duty Lathes

http://www.taunton.com/finewoodworking/ToolGuide/ToolGuidePDF.aspx?id=28529

Lathes for Turning Big Bowls

http://www.taunton.com/finewoodworking/ToolGuide/ToolGuideArticle.aspx?id=28509

Turn a Green Wood Bowl: Cutting Blanks

http://www.taunton.com/finewoodworking/SkillsAndTechniques/SkillsAndTechniquesArticle.aspx?id=5280

Re: Fine Woodworking.com, Lathe Article & Video Links

#2

Re: Fine Woodworking.com, Lathe Article & Video Li

Peter Hyde

>I took a look at this one "Turn a Green Wood Bowl: Cutting Blanks" and was horrified! Unsupported log on concrete, not 1 piece of safety gear, he even stands one log on another to make cuts. FWW is really being irresponsible. Just another indication of how far this magazine has gone down the tubes.

Re: Fine Woodworking.com, Lathe Article & Video Links

#3

Brad Vietje

Re: Fine Woodworking.com, Lathe Article & Video Li

Brad Vietje

>It was fun to look at these:

I wasn't bothered much by the chainsaw segment except the complete lack of safety equipment and the back cut to separate the pieces once the log was stood up on end -- that can be dangerous and tricky for beginners,and that should have been pointed out. Truth is, if you are only cutting part-way through, then rolling the log over, it doesn't matter what's below, though that wasn't made clear to the viewer, either. I often rest one log on another, IF the bottom one is big & flat enough, and there are no doubt many here who do. There aren't any wild forces in play, so that part didn't bother me at all.

What REALLY got me was this fellow's use of the bandsaw. He seems to have all fingers on both hands, but his left thumb and wrist are WAY too close to that blade, and if he runs into an unexpected bark inclusion, he could take his hand off in no time. He may be a hardened professional (I don't know the fellow), but he's getting really careless.

Andy Barnum is a hoot -- nice guy, very experienced and talented, and it was fun to watch him on the lathe video.

Thanks for posting those valuable safety lessons !

Safe spinning,

Brad Vietje

Newbury, VT