Steve... I have started...
dwr
>... a running tab on the cost several times and have not updated anything for a few months. I have two sets of costs: One that represents the actual cost (including mistakes, parts that didn't work, upgrade parts you can't pass up, etc.) which are the bane of a prototype, and another that represents what it would cost if repeated without all the "mistakes" and what I have learned along the way. I set a goal for $2500 and I know I have exceed that.
I also looked at it from a standpoint of what was available commercially for 48" diameter and larger blanks ( I can turn 96" before it hits the floor) and what they would cost. I am significantly under that price range.
There are many points to consider, including how much you can do yourself, how much help you can get from friends (welding, machine work, electrical, etc.) and what you have to pay full bore. If you are patient, you can get some serious components on EBay for pennies on the dollar. Case in point; I got my new TB Woods 5HP VFD for less than $200 and it retails for nearly $1,500 (one of those upgraded parts I couldn't pass up.) In my case, I had to pay for everything except some electrical work that I traded out for some woodworking.
So, the target is a moving target that changes with opportunities, design challenges and new ideas. If someone wanted to replicate this lathe, with it's capacities, using the same machined components, getting the misc. steel parts from steel salvage places (I pay .35/pound for all the steel used for the tool rests, tail stock, pivot mounts, etc... which I have not shown yet), got a basic powder coat color, paid a reasonable fee for welding and electrical, and shopped EBay for high quality componets... I believe it could be done in the $3K arena. If you can weld, machine, do electrical, or have access to people that will do it for free, you can save several hundred dollars.
Long answer to a short question... I just have not stopped long enough to sort everything out... I will sometime over the summer as I do construction documentation of the entire process ( I have hundreds of pictures, etc.) and make a coffee table book for the living room.
If you go down this road, I am willing to help you, or anyone else... so you can learn from someone else's expensive lessons...;)
Dave... who is glad it is nearly over so I can prove to my wife it was worth it...;)!