Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Repairing tool rest wobble?

Posts

Repairing tool rest wobble?

#1

Repairing tool rest wobble?

wilbur

>I have a 60 year old Walker Turner lathe that I purchased recently. I've noticed that my tool rest has a bit of a wobble in it. Holding it, I can't reproduce the wobble, but if I clamp the tool rest in the banjo I can make the rest wiggle a little bit around the post.

I'd just get another tool rest, but the post of the tool rest has an unusual diameter, so a replacement has been hard to come by. My bet is that rebrazing/rewelding the post will fix this, but I'd like to check before doing something permanent to the tool rest.

Suggestions? What would be the best way of fixing this?

Re: Repairing tool rest wobble?

#2

Re: Repairing tool rest wobble?

Ken Grunke from SW WI

>What's the diameter of the banjo's hole? Whatever it is, you might consider having a machinist turn a reducer sleeve. If the difference between existing diameter and desired diameter is small, a thin sleeve can be epoxied in with an oversize clearance hole for the lock screw to go through.

Re: Repairing tool rest wobble?

#3

Re: Repairing tool rest wobble?

wilbur

>The tool rest has a 3/4" post. Just to clarify, it's the horizontal section of the tool rest that wiggles around the toll rest post. The connection between the banjo and the tool rest post is solid.