Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Parts for Craftsman Lathe

Posts

Parts for Craftsman Lathe

#1

Parts for Craftsman Lathe

Jay Fischer

>Does anybody have a lead on where I can find parts for an old Craftsman 12" lathe? The bolt for the shoe clamp that holds the tool rest assembly has slowly become stripped and no longer holds. It's a "special" bolt with a nut welded to it and the adjustment handle welded to the top. I'm dead in the water until I get it fixed.

Is there a good replacement tool rest assembly that would fit the 2 1/4" diameter base? I wouldn't mind having something sturdier than the stock part.

Thanks!

Jay

Re: Parts for Craftsman Lathe

#2

Steven Antonucci

If I read this right...

steve antonucci

>it's one of the locking handle bolts that are stripped, and not the banjo?

In a pinch, you can remove it and replace it with a regular hex headed bolt that you can tighten with a wrench. Not the fastest, but you probably have the ability to turn again in less than a minute while you search out that bolt.

Steve

Re: Parts for Craftsman Lathe

#3

Re: If I read this right...

Jay Fischer

>you may be correct. one of my friends, though, thought the bolt had "special", as in non-standard, threads. i'll check at the hw store tonight.

thanks,

j

Re: Parts for Craftsman Lathe

#4

Re: If I read this right...

Denis Putland from Saskatchewan

>and the treads are stripped in the banjo casting then just beg borrow or buy a tap for a bolt one size bigger and redo the threads in the casting.

Anther option is drill the casting out for similar bolt to slide though and then weld a nut to casting.

Much prefer the first option, been there, done that.

Denis

Re: Parts for Craftsman Lathe

#5

Re: Parts for Craftsman Lathe

Gary Evans Tallassee, TN

>Hi Jay,

If I am correct in assuming that this is one of the Craftsman lathes with the single tube bed, then I have a deal for you. I have a complete lathe that I would gladly let you have. I don't think it is operational, but I've never taken the time to find out.

You pay the shipping from 37878 and I'll box it up and send it. I would estimate 75 to 100 lbs for shipping weight, but I could be way off base. Someone else here may have a better estimate. I would expect Fed-Ex Ground to have the best rate.

Gary

Gary

Re: Parts for Craftsman Lathe

#6

Re: Parts for Craftsman Lathe

Walt Ahlgrim

>When I had a knock off of that lathe, it was the cast iron that failed. Try picking at the threads on the steel bolt with a dental tool, I think you will find the bolt is in good shape after you clean all the piece of cast iron out of its threads. Mine was a standard 8MM thread. The local auto parts store had a heli-coil kit that worked great.

WaltA

Re: Parts for Craftsman Lathe

#7

Re: Parts for Craftsman Lathe

Jay Fischer

>No, on mine, the threads are completely gone in one area of the bolt. I just went to Ace and got a hex head bolt of the same size and some washers and am using an open head wrench to adjust.

Thanks!

Jay

Re: Parts for Craftsman Lathe

#8

Steven Antonucci

Glad that worked for you...

steve antonucci

>