Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

bandsaw problem

Posts

bandsaw problem

#1

bandsaw problem

jim johnstun

>Have a Grizzely band saw with roller bearing guides. When cutting wet bowl blanks,The blade and bearings get covered with pitch etc. Have tried Pam and WD40. Neither worked that well. Anyone else have this problem? What is the solution?

Re: bandsaw problem

#2

Re: bandsaw problem

Ken

>Try woodcraft or just about any of the supply house's and you should be able to pick up some pitch .I can't think of the proper name for it,but you can clean your blades and mach without damaging anything.

Ken

Re: bandsaw problem

#3

Re: bandsaw problem

Ken

>pitch remover

Re: bandsaw problem

#4

Re: bandsaw problem

Brian Hahn in SW Wisconsin

>Switch to cool-block guides when cutting green wood. They help keep the blade body clean.

Re: bandsaw problem

#5

Re: bandsaw problem

john lucas

>I agree with Brian. I sold a cheap bandsaw that had cool blocks and went to a Delta with roller bearings. I really like them for resawing but I have the same problem as you when cutting green wood. What I do is take a scrap piece of wood and push the blade gently toward one bearing to make that bearing spin. Then I use the corner of another piece of wood to scrape the crud off the spinning bearing. Then I'll do the other one. I also use the corner of the wood touching each side of the blade to clean it.

Re: bandsaw problem

#6

Dri-Cote might help

Curly Smith

> Dri-Cote

"Dri-Cote is formulated for use on high-speed cutting tools such as shaper cutters, saw-blades & router bits. By locking a low-friction, high-temperature resistant coating into the surface of carbide or steel cutting tools, Dri-Cote significantly slows accumulation of baked-on resins & crud that increase friction, inhibit chip clearance, and generally make edges act dull. Used regularly, Dri-Cote reduces chemical corrosion of carbide tooling, and can noticeably extend edge life when cutting synthetic materials such as Corian or sheet meterials with abrasive adhesives."

Re: bandsaw problem

#7

Re: I have the same problems with...

Jamie Donaldson

>...my MiniMax 18" and all those rollers that compress "stuff" on the edges as well as on the blade. Never had the build-up problem with the old Delta and cool blocks, and am considering installing cool blocks on the MiniMax if I can find a retrofit source- any suggestions??

Re: bandsaw problem

#8

Re: bandsaw problem

jim johnstun

>Thanks for the info. Will call Grizzly. Someone said that they offer coolblocks for my saw.

Re: bandsaw problem

#9

Re: bandsaw problem

James McClure

>The Highland Hardware woodturner blades don't seem to gunk up as bad. Maybe it's because they cut a wider kerf or maybe it's because they are smoother on the sides. Of course, sometimes they will still gunk up and when that happens I do like John was saying.