Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

How I turn a sphere *LINK*

Posts

How I turn a sphere *LINK*

#1

How I turn a sphere *LINK*

Brian Simmons, Heflin, AL

>I set up this page to show an easy way that I have taught myself to turn a sphere. I have only turned 5 using this method and can do it in about 50 minutes from start to finish. Hope it my give someone some ideas. Comments are welcome.

Brian


sphere

Re: How I turn a sphere *LINK*

#2

Re: How I turn a sphere

Jennifer@Indy.USA

>That's a darn good looking sphere, Brian!

Thanks for the tutorial.

Jen

Re: How I turn a sphere *LINK*

#3

Re: How I turn a sphere

Tommy Holmes

>Great tutorial. Thanks for taking the time to make it and making it available.

Re: How I turn a sphere *LINK*

#4

Re: How I turn a sphere

john lucas

>Brian That's the way I learned to do it but without a vacuum chuck. I place a piece of wood in the chuck and turn a slight depression to help drive the ball. Then I make an adaptor for my tailstock to that also has a slight depression. I use this to Jam chuck the ball between the the two. Then I can rotate the ball wherever needed to get rid of the tenons. Ill look to see if I still have those adaptors and post a photo.

Thanks for Posting it's a great tutorial.

Re: How I turn a sphere *LINK*

#5

Re: How I turn a sphere

Mark Wollschlager

>The method I learned has a wooden 'chuck' with a depression on the headstock end, but a flat on the tailstock end. It leaves a shiny spot on the sphere, but allows you to get in closer for finishing.

Many methods are available to achieve the goal.

Mark

Re: How I turn a sphere *LINK*

#6

Re: How I turn a sphere

Charles B. Watson

>Thanks for posting. And congratulations!!

Re: How I turn a sphere *LINK*

#7

Re: How I turn a sphere

Jorge Castaneda

>Brian,

Good tutorial,

Thank you for sharing

Jorge

Re: How I turn a sphere *LINK*

#8

Question

Ken Grunke from SW WI

>Brian,

in step 3, when you turn the blank 90 degrees, how do you locate the centers on the ridge? Trial and error, measurement, or with the indexing holes in the spindle?

Thanks for posting this, I'll be giving it a try.

Re: How I turn a sphere *LINK*

#9

Re: Question

Brian Simmons, Heflin, AL

>I measure to find center and spin my line so that I know where to leave the ridge. I then use the pin hole in the spindle as a guide, pin straight up and draw line along rest edge, pin down and repeat. This gives me 2 marks pretty close to exactly opposite without an indexing unit.

Good Luck