Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

3520 A /B difference

Posts

3520 A /B difference

#1

3520 A /B difference

robo hippy

>I was playing around with the minimum speed (rpm) on a 3520 B model, and it would shut off at around 50 rpm. I was thinking that my old A model would go slower. Today, I was playing around with mine, and it would go down to 20 rpm or even a little less. What's it good for??? Well, some of my bowls are pretty warped, and on the bigger ones if I want to sand while the lathe is turning, it would be better for that, but I don't know what else.

robo hippy

Re: 3520 A /B difference

#2

Re: 3520 A /B difference

eliot d

>When power sanding, I often find that I can't get the job done properly with the lathe turning fast, so I stop the lathe and power sand by just moving the piece around to where the problem areas are by rotating the spindle wheel with my left hand. Or I can accomplish almost the same thing with the lathe turning as slow as possible, which as you say , on my 3520A is very slow indeed.

Re: 3520 A /B difference

#3

Re: 3520 A /B difference

Mike Nelson

>I use the slow speed for drying finishes evenly.

Re: 3520 A /B difference

#4

Re: 3520 A /B difference

eliot d

>Another idea. I turning friend uses fairly thick epoxy finishes and gets them to dry evenly on something like a rotisserie. I suppose you could use the very slow speed on the Powermatic for this.

Re: 3520 A /B difference

#5

Re: 3520 A /B difference

John Lucas

>It may be a little bit fast for this. My friend who does epoxy finishes has a 6 rpm motor to drive his bowls while drying.

Re: 3520 A /B difference

#6

Re: 3520 A /B difference

eliot d

>I think you're right; and I wouldn't really want to use my lathe that way. I was straining to come up with some use for really low speed.

Incidentally, the fellow I know who uses epoxy finishes gets just about the best finishes anywhere. I always marvel at them -- and I have seen plenty. But his epoxy stuff is really expensive -- something like $200 for several gallons.