Tall Beaded Vessel.....
Wally Dickerman in Arizona
>This spalted maple burl vessel is 10.5 inches tall x 6 inches wide. Turned a couple of years ago.
Wally
Knowledge You Can Build On — Est. 1998
Tall Beaded Vessel.....
Wally Dickerman in Arizona
>This spalted maple burl vessel is 10.5 inches tall x 6 inches wide. Turned a couple of years ago.
Wally
Re: Tall Beaded Vessel.....
Ruth Niles
>Wally, I love your beaded vessels. And, like you, they just get better looking with age. (is that worth points?) : )
Re: Tall Beaded Vessel.....
Thomas Skaggs, Foothills of Mount Level
>Wally,
Your beaded vessels are always among my favorites of your work. Whenever I see one I immediately know you made it. Beautiful.
Tom
Re: Tall Beaded Vessel.....
Wally Dickerman in Arizona
>Thanks Ruth....Oh yeah, lots of points.
I had the same experience that you did when I had a General 260. Hit the switch while a faceplate was loosely attached. The faceplate was just about bonded to the spindle. I actually broke the wrench that General supplied with the lathe while beating on it with a mallet. I bought an oversized crescent wrench and beat on that to loosen the faceplate. I still have the large wrench but haven't had to use it since.
Wally
Re: Tall Beaded Vessel.....
George Van
>As usual, beaded perfection! Whenever I think I am getting beading down I am reminded by your vessels that I need to practice a lot more.
Re: Tall Beaded Vessel.....
C.W.Stivison
>Give Ruth alot of points, she did bend a monkey wrench ya know.
CW
Re: Tall Beaded Vessel.....
Wally Dickerman in Arizona
>Thanks for your comments folks.....
Wally