Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Need help completing air filtration cabinet

Posts

Need help completing air filtration cabinet

#1

Need help completing air filtration cabinet

Wayne Leach-NW Ontario

>Hi All,

I have a cabinet into which I installed a surplus furnace blower assembly which has the motor mounted within the blower. I hooked the motor up to 120volts using the black and white wires from the motor (there are 5 wires hanging from the motor). It runs great, but way too fast - if I put wings on it I could probably get it airborne.

My question is, these things usually start at slow speed, shift to med and then to high in a heating situation. I would like to run it slower but unsure whether I need any controller in between or just hook up the red wire instead of the black or maybe even the yellow wire?

Will I have a meltdown if I try this. Does these motors have the speed control built in???se

Amy help would be appreciated.

Thanks in advance,

Wayne

Re: Need help completing air filtration cabinet

#2

Leo Van Der Loo

Re: Need help completing air filtration cabinet

Leo Van Der Loo

>Hi Wayne, these furnace motors have the wire go trough the windings different as far as I know, anyway I have wired a couple up, and have put one on my high efficiency gas furnace, where it works on the lower rpm for air conditioning.

The slow speed is only a few hundred rpm lower though, not a whole lot, there should be a diagram with/in the motor to tell you which wires are for what, that's been my experience.

Have fun and take care

Leo Van Der Loo

Re: Need help completing air filtration cabinet

#3

Re: Need help completing air filtration cabinet

Tommy Holmes

>I got one from an AC guy a few weeks (haven't made my box yet). The instructions he gave me were:

Black = High

Blue = Medium

Red = Low

Hope this helps.

Re: Need help completing air filtration cabinet

#4

Re: Need help completing air filtration cabinet

Bob Fawcett

>I think this matches the one I have and use. Mine is made by Emerson Electrice.

You may find a motor plate on it. If you do - you can probably find a wiring diagram on the net. I found one for mine.

Re: Need help completing air filtration cabinet

#5

Re: I agree, Tommy...

Allen Neighbors

>same as I've found out using hook and crook. :)

Red seems to be the slowest speed. Black is higher... I didn't even try the others.

Re: Need help completing air filtration cabinet

#6

Re: Thank you to everyone who replied

Wayne Leach-NW Ontario

>Especially to Tommy who nailed the wiring colors.

I hooked up the red and its much quieter running at slightly slower speed. Its working and should keep the dust level down.

Wayne