Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

American Beech pot 4.25"x 3.5"

Posts

American Beech pot 4.25"x 3.5"

#1

Leo Van Der Loo

American Beech pot 4.25"x 3.5"

Leo Van Der Loo

>This one was turned twice, first to approxi 3/8" then dried for 3 months and finish turned, sanded and waxed, it did split open 3/4" on the belly and closed again as it dried, but is still visible, (not on the pic).

Comments welcome.

Have fun and take care

Leo Van Der Loo


img

Re: American Beech pot 4.25"x 3.5"

#2

Leo Van Der Loo

Re: American Beech pot 4.25"x 3.5" 

Leo Van Der Loo

>


img

Re: American Beech pot 4.25"x 3.5"

#3

Re: American Beech pot 4.25"x 3.5"

Jennifer@Indy.USA

>Me Likey, Leo. Juicy form!

Very nice.

Jen

Re: American Beech pot 4.25"x 3.5"

#4

Steven Antonucci

I haven't turned beech in 7 years...

steve antonucci

>There are big beeches throughout the neighborhood, bu they seem to weather the storms pretty well. There's a huge (80' tall x 3'+ diameter) beech just a few yards from my house... going to make a big boom when it comes down!

My only experience with beech is that unless you turn it thin in one pass, it's going to split, and mercilessly at that! I had a similar shaped form that opened a crack that was easily 3/4" across the form. Made for some pretty firewood.

I agree with Jen- although I'm not sure that I'm allowed to use the word juicy to describe a piece of wood. When pots like that split on me, I've started putting in a spline or a butterfly like the Hawaiian Pewas to hold them from splitting any more.

Steve

Re: American Beech pot 4.25"x 3.5"

#5

Leo Van Der Loo

Thank you for the response Jen, have fun&take care

Leo Van Der Loo

>

Re: American Beech pot 4.25"x 3.5"

#6

Leo Van Der Loo

Re: I haven't turned beech in 7 years...

Leo Van Der Loo

>Thank you Steve, I have rough turned several bowls all from this one log I got from my brothers place, he cut it just before new years, this one was growing from under a larger Beech and leaning a lot, some of the lower branches were now rubbing his roof shingles, so he had to come down.

The wood has a lot of tension grown in and is moving a lot on the thin bowls, I made also a thin shallow dish and it looks like a potato chip now.

The larger bowl warped a lot, and is an inch longer than wide now, the finished wood is as smooth as a baby's b@#!, I'll see how the other ones fare.

We had a large red beech close by my place in the Netherlands, took more than three grown persons to get around it, and the branches were 39 feet from one side to the other.

They steam the wood often in Europe to prevent the problems with Beech.

Have fun and take care

Leo Van Der Loo

Re: American Beech pot 4.25"x 3.5"

#7

Re: American Beech pot 4.25"x 3.5"

Wayne Leach-NW Ontario

>Too bad about the crack Leo-can you fix it?

Looks pretty thin and nice form. Good work as usual!

Wayne

Re: American Beech pot 4.25"x 3.5"

#8

Leo Van Der Loo

Sorry Wayne, for not responding, hadn't seen your

Leo Van Der Loo

>post until this evening, I did glue the split Wayne, but it will always be visible, it had opened up to about 1/16" wide and 3/4" long when I first saw it, only 2 days after I had turned it and placed in a paper bag, I realized I should have left less air space around it, but it was to late then, so I just place it back in the bag and closed it up smaller that time, wasn't sure how far it was going to open up, and a couple more days later it seemed the split was getting narrower, and yes it closed up completely, but on the outside only, so after returning it I had this narrow split showing, and then glued it with CA.

It might be a good candidate for some brass wire, if I ever get time for it.

Have fun and take care

Leo Van Der Loo

Re: American Beech pot 4.25"x 3.5"

#9

Leo Van Der Loo

Re: Sorry Wayne, for not responding, hadn't seen y 

Leo Van Der Loo

>


img