We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>I posted the second photo back on March 15th asking for crack filling suggestions. I experimented with several of the good suggestions. I ended up filling the crack with 5 minute epoxy and fine coffee grounds. The epoxy held together better then CA glue and it did not shrink or chip. Comments are welcome. The HF is 6.5" dia x 8" high, 1/8" wall with a 1.5" opening and a 2" base. It was finished with Waterlox and buffed.
>Nice job filling the crack. Did you do this with the Don Derry hollowing rig. I still need to call you so we can work with the larger setup. I'll find time to get up to Pennsylvania one of these days.
>This was one of the last HF's that I blind hollowed. I made about eight HF's using Don's hollowing rig so far. I used the larger bar today and it works well but I need to try it out on a taller HF. I am still waiting for my larger Oneway jaws to arrive. Give me a call in a couple weeks and we can set something up.
By the way I blew up a really nice HF Saturday during a class of course. The cutter was a half inch off the bottom center where the catch occured. It was just one minute from completion. The cutter was about 1/16th above centerline. So today I made sure I adjusted the tool post collar and set the tip 1/16 below center. Everything went perfect since no one was watching.
>Andy, you did well!! Nice looking hollowform. I agree that using epoxy with 'whatever' is better than CA. Sometimes the CA sets up before you can get the medium packed tight enough, and holes develop during sanding.