Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Sander for segmented turning

Posts

Sander for segmented turning

#1

Sander for segmented turning

Tom Toupin

>Ihave gone through two ShopFox 12" disc sanders in two months motor and bearing problems. I am wondering if anyone thinks I would have more luck with the Delta 31-120 12"disc sander. I only use it to sand segments for bowl rings Thanks for your input Tom T. in AZ.

Re: Sander for segmented turning

#2

Re: Sander for segmented turning *LINK*

Bob Fawcett

>Tom,

I built this one a few weeks ago.


Disk Sander

Re: Sander for segmented turning

#3

Re: Sander for segmented turning

Pete LaBelle

>If only the bearings are bad, new ones are suprisingly pretty cheap, and probably of higher quality than what was in the machine originally. Make sure to get sealed, and not just shielded bearings. If they're still under warranty, get a new one.

Also guess that most disk sanders have normal ball bearings in them, which are not the greatest to absorb thrust. Are you pushing too hard on to too fine or dull of your abrasive paper ? Just a thought.

Re: Sander for segmented turning

#4

Re: Sander for segmented turning

Mark Kauder, Phenix City, AL

>Tom,

Though I do not use it for sanding all my segments, like some, I do have a Delta, and like it and find it to be a robust enough sander. Curt Theobald uses the Deltas, though I think his are the older and even more durable ones.

I have found that the table can move off square, but I attribute that to me possibly not tighting as much as I could. But I am afraid of breaking off a screw in the cast iron bed. So I keep a machinist's square near it and tap the bed to make it square when I need that funtionality. Some day, I might fix that, but as I said, I do not sand my segments, other than to occasionally touch one up.

There are more robust sanders out there (20" Powermatic?? $2500??), but for the money I think the Delta is a good tool.

Mark

Re: Sander for segmented turning

#5

Wixey angle gauge *LINK*

Stuart Johnson

>I use a Wixey angle to keep shop tools square. Plus it is great for cutting compound angles on the table saw.


Wixey Angle Gauge

Re: Sander for segmented turning

#6

Re: Sander for segmented turning

Dennis Daudelin

>I like my Delta Disk Sander. I've had it for ~2 years and only use it for sanding half rings of segmented projects.

One of the considerations that I look at when buying a machine is it's maintenance. On this machine, there are 4 bolts (with nuts, washer and lock washer) to hold the table in place. Then there are 4 phillips head screws for the dust collection port. Changing the paper ends up being pretty simple!

I also think that the dust collector works pretty good! And since it's saw dust that's important.

The only thing that I wish is that it was larger. I made lots of 10+ inch bowls and the sander is just a touch small for those half rings. I'm going to keep an eye out for a used larger sander, I'll find room in the shop for it. But until then (maybe forever) the Delta is working well for me!

Good luck!!

Dennis

Re: Sander for segmented turning

#7

Re: Sander for segmented turning

Dennis Daudelin

>Just a quick note on new, larger disk sanders:

Powermatic 20" - $1999.

Woodtek 20" - $1399.

Makes the Delta price look good!!

Dennis