Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

compressor repair

Posts

compressor repair

#1

compressor repair

john lucas

>I bought a cheap air compressor a few years ago. It did the job but when it died the troubles began. I needed an overheat thermostat and an air pressure switch. It was nearly impossible to find either one. By the time I found the parts and then bought new pieces of pipe and hose and other odds and ends to fix it I have nearly $80 in parts to repair a $167 air compressor. Bummer. Oh well I'll just save up for a new compressor. Next time this one dies I will have saved the money to buy a good one.

Re: compressor repair

#2

Re: compressor repair

Ken Grunke from SW WI

>John, a few years ago I built a compressor using a propane tank and plumbing parts, with a refrigeration pump unit. I used a pressure switch intended for a water pressure tank, used in well systems. I think you can set them to a max of about 100 psi, and they're about $40 last time I checked. I would have just bypassed the overheat switch, was that really needed on your compressor?

Re: compressor repair

#3

Re: compressor repair

jwoodwright

>John,

Do you vacuum chuck? When you get a new compressor, that old tank can be used as a vacuum reservoir. That way, if there is a power failure, you can save the turning...

Re: compressor repair

#4

Re: compressor repair

john lucas

>I'm thinking about converting one of my extra propane tanks to a vacuum reservoir. The power went out one time while I was finishing a bowl in my old shop. That's really exciting having something bouncing around the room in total darkness.

Re: compressor repair

#5

Re: compressor repair

john lucas

>I got the pressure switch for $39. The problem was I couldn't figure out what to order. They don't give any specs. I went to Grainger and ordered what I thought was correct but mine has a seperate tube attached to it. I had to send it back and get another. I think I need the overheat switch because I use this compressor too much so I probably need the protection. I did wire around it initially to keep it running.

Re: compressor repair

#6

New game? Dodge bowl!

tek-Brunswick, Ohio

>

Re: compressor repair

#7

I didn't know where to dodge. :)

John Lucas

>