Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Chuck mounted faceplate rings

Posts

Chuck mounted faceplate rings

#1

Chuck mounted faceplate rings

wilbur

>I am thinking of getting a small faceplate, about 3" or so. I've learned that I can get a faceplate ring and mount it to my Vicmarc chuck. Is there any disadvantage to this as opposed to just using a regular 3" faceplate?

Re: Chuck mounted faceplate rings

#2

Peter Charles Fagg (UK)

Re: Chuck mounted faceplate rings

Peter Charles Fagg (UK)

>Hi, I do not have the Vicmarc chuck but I have used this method for years. It makes life easier if I can mount several faceplate rings on the pieces to be worked and then take them in sequence. Underside first for all 5 unscrew the plate then work all 5 bowl insides one after the other.

There can be some slippage with large pieces but have not experienced any big problems.

Regards, Peter.

Re: Chuck mounted faceplate rings

#3

Re: Chuck mounted faceplate rings

John Lucas

>I'm not sure. I bought one with the idea of mounting wood on it so that I could dismount it and keep the alignment. I've never used it. However I'm glad you reminded me of this tool. It might be the perfect thing for my router techniques. It would allow me to rotate the piece very slightly to achieve different affects. It would be hard to do that with wood because the compression of the jaws will change the orientation.

Re: Chuck mounted faceplate rings

#4

Re: Chuck mounted faceplate rings

Rick Allen

>The faceplate rings have a few advantages:

Can work with several different chucks and is independent of the thread of the headstock spindle.

Leaving the faceplate ring on the workpiece makes storage of the workpiece easier as the spindle hub isn't a balance point

The main disadvantage is that the rings are not as stiff as a good faceplate.

There is a mechanical connection between the ring and the chuck

Re: Chuck mounted faceplate rings

#5

Make your own from aluminum plate *LINK*

Ken Grunke from SW WI

>For the do-it-yourselfers, you can turn aluminum with woodturning tools.

If you don't believe me, look at the link below.

Get some 1/4" aluminum plate, cut into a rough circle with a 1/4" center hole. In a piece of scrap wood chucked in the lathe and faced off flat, drill a 3/16" hole with the jacobs chuck in the tailstock. Fasten the plate to the wood with a lagscrew and with the lathe set at about 500 rpm (lowest range on many currently available lathes) turn the perimeter to an angle equivalent to the angle of your chuck jaws using any HSS spindle gouge. Aluminum turns just like wood, but it's much more slower going of course. You can get curling chips just like wood, even when turning mild steel.


Turning metal on the wood lathe

Re: Chuck mounted faceplate rings

#6

followup

Ken Grunke from SW WI

>Argh, I hit the "post" button too soon.

After getting the perimeter turned to your satisfaction, you'll want to drill holes for the screws. Use a sharp-pointed tool to scribe a shallow v-groove in the face of the plate, where you want the holes. If you have an indexing setup on your lathe, use that to space out the holes and just drag a scriber across the toolpost at the centerline. Then centerpunch the holes and drill'em. The holes in the side facing the chuck should be countersunk so the screws don't interfere with the chuck jaws.

Re: Chuck mounted faceplate rings

#7

Re: followup

Barry Elder

>Have used the rings for two years and makes life much more simple. Common sense says don't overload! Depends on whether the wood is green or dry.