Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

CPM V10 vs M2

Posts

CPM V10 vs M2

#1

CPM V10 vs M2

john lucas

>Well I'm a little more confused. I took both 3/8" spindle gouges and ran them through the carving tool sharpening regimine. I was able to polish the M2 steel to a mirror finish. I was only able to get a satin finish on the V10. Here's where the odd thing comes in. They both cut the same. Well actually the V10 seemed to cut better when pushed across the grain by hand on a pine board.

I decided to test them cutting some really dry box elder. This stuff has bee notorious for tear out unless the tools are really sharp. Both gouges cut extrememly clean cuts.

This tells me that properly sharpened both cut the same. Now I've got to do a little test to see how best to sharpen the V10. Perhaps yesterdays test using the 100 grit grinding wheel was a fluke.

I'll try to test some more as the days go by. This is interesting steel.

Re: CPM V10 vs M2

#2

Re: CPM V10 vs M2

Steve Worcester

>You will probably find out the V10 would hold the edge longer, and if you would go to way high grits (technical term for greater than 600 or so) the V10 will not sharpen as well.

Steve Worcester

www.turningwood.com

Re: CPM V10 vs M2

#3

Re: CPM V10 vs M2

john lucas

>Steve That doesn't seem to be the case. I went through the grits and buffed the edge. Even though it didn't seem to have a mirror finish it cut better than the M2 when hand pushed through ghe wood. it seemed to cut the same or better when applied to turning wood. I still have more tests to do to figure out what's going on.