Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Shop made disk sander

Posts

Shop made disk sander

#1

Shop made disk sander

Bob Fawcett

>I built this sander last week. Just an MDF disk glued to a block of hardwood and a plywood platform.


img

Re: Shop made disk sander

#2

Re: Shop made disk sander

Bob Fawcett

>The hardwood is tapped to fit the spindle. The hole is for a set screw I plan to add to prevent it unscrewing itself when I stop the lathe.


img

Re: Shop made disk sander

#3

Re: Shop made disk sander

Bob Fawcett

>The platform clamps the lathe bed with a plywood block and there are 2 hardwood runners to help locate it.


img

Re: Shop made disk sander

#4

Re: Shop made disk sander

Ron in Drums PA

>Great!!

Have you considered making a dust port in the base?

Re: Shop made disk sander

#5

Re: Shop made disk sander

Allen Neighbors

>Bob, that looks really well done. Looks good on the Mustard Monster. :o)

Re: Shop made disk sander

#6

Re: Shop made disk sander

Bob Fawcett

>I haven't used it yet as you might can tell. A dust port would be a good idea. Any suggestions?

Re: Shop made disk sander

#7

Re: Shop made disk sander

Bob Fawcett

>thanks Allen.

Re: Shop made disk sander

#8

Re: Shop made disk sander

Bruce in Saint John,N.B.

>A really slick idea Bob, I think I will put this idea on my back burner for a future project. Thanks for posting.

Re: Shop made disk sander

#9

Re: Shop made disk sander

Ron in Drums PA

>Keep it simple

Turn your box 180 degrees so the opening in on the sandpaper side. Place the knob under the ways. Cut a 4" hole on the closed side (or whatever your dust collector accepts). Epoxy in a PVC pipe into the hole. Connect the dust collector hose to the PVC pipe and you are set.

Show us a picture when you are done.

Re: Shop made disk sander

#10

Re: Shop made disk sander

Denis Putland from Saskatchewan

>A great idea and a nice job.

I do have one concern about using a hard wood face plate.

I have made and used many hard wood face plates and I find that they do not always remount to run 100% true.

It is probably due to wood movement and also the wood threads are not perfectly solid as in a steel face plate.

I think I would use a dedicated steel face plate for accurate remounting.

Just my 2 cents worth.

Denis

Re: Shop made disk sander

#11

Re: Shop made disk sander

Bob Fawcett

>I cut a small amount of the threads out at the headstock side and turned the end flat so it seats against the flat of the spindle. I hardened the threads with CA glue. I have it marked so I can see where it seats each time. So far it stays in the same place. We'll see if it moves.