Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Turning Blanks

Posts

Turning Blanks

#1

Turning Blanks

Ken Oakley-Sunny St. Cloud, Fla.

>I have been cutting citrus woods such as Orange, Grapefruit and Tangerine into 13/16" sq. by 6" blanks and selling them on Ebay. Been doing pretty good with it. My problem is sometimes I have pieces shorter then 6" that I don't list because most pen blanks I see on Ebay are at least 5 3/4" long. Are there items that can be turned from these shorter pieces? How about pieces that are larger then 13/16" sq. but shorter then 5 3/4"? I hate to keep giving these shorter pieces to my neighbor for his smoker if I could make blanks that I could sell on Ebay and make some more money. I see a lot of discussions about finials. How about Tops? Need suggestions. Thanks

Re: Turning Blanks

#2

Re: Turning Blanks

Bill Howatt

>I and I assume other penturners cut the blank into 2 pces before drilling anyway. Unless it is a one piece pen, there is the upper and lower section. For the common 2 pce pens each piece is really about 2-1/4" long.

Some people may want the grain to be a good match so this is one aspect to consider and perhaps you could try and match pieces. You could also sell these pieces at a slightly reduced rate. I think you just have to be up-front about what it is you are selling.

Bill

Re: Turning Blanks

#3

Re: Turning Blanks

Russ Babbitt

>Some pens only require one blank. You can sell your shorter ones as "half blanks". Check Ebay, others sell them as such. Just make sure your descriptions are accurate.

Re: Turning Blanks

#4

Re: Turning Blanks

eaglesc

>MOst Parker style pens require a FINISHED lower section of 2&3/8ths for the bottom. and around 2&1/8th for the top/

The sortest blank is the Sierra or wall st which is a FINISHED 2&1/4"(single tube)

Re: Turning Blanks

#5

Re: Turning Blanks

eaglesc

>You could take the shorts and make segmented spiral blanks and sell them.

Re: Turning Blanks

#6

Re: Turning Blanks

Tony - Memphis

>I buy the little screwdrivers at Lowe's for about $1.97 and cut the plastic handles off of them. i then drill a hole in a blank and epoxy the screwdriver into the blank. I use a drill chuck to hold them. You can use short blanks for these. They make nice gifts.

Tony

Re: Turning Blanks

#7

Thanks to all

Ken Oakley-Sunny St. Cloud, Fla.

>I guess I will just try listing various sizes on Ebay and see what gets the best response. I am sure there are many differant items that can be made with my cutoffs. It is just a matter of size and price. Thanks again.

Anymore suggestions will be greatly appreciated.